Search results

ISO - Looking for a Missouri car license plate for either of the years 1949, 1950, 1951, 1952, 1953, 1954. Just need one plate. These plates had a couple slots for a metal year tab to be inserted. I have the metal tab but need the plate. I think in 1953 and 1954 the tab was replaced with a...

Does anyone know where I can find this lens. Not sure of the year. (37, 38, 39, 40, 41 - ?). I would like to find 2 or 3 of them if possible. Any help would be appreciated.

Hello. I now have another problem that I just discovered. Not sure what it is yet. Been working on my carb and got it running again when I noticed what I think is a fuel problem. When my car is running I noticed that my big clear fuel filter did not have much gas in it. I watched it for...

Can anyone identify this carb. It's on a 302. There is no tag on it, only has a stamp on the front of base on drivers side that reads 7DKA. I think it is a Motorcraft 2100? Car was running fine, then I removed it to clean all the gunk off the outside, did not open it up or anything, now...

My volt gauge reads about 12.3 volts. Removed the alternator and new battery and took to O'Reilly's and both tested around 14.5 to 14.6 volts. Next thing I did was cleaned all ground contact points, even added ground straps from engine to frame and fender to engine. Replaced battery and...

Looking for a Town Sedan chrome bezel for a 55 Ford that goes on rear quarter. Needs to have all mounting studs and not rusty or pitted.

I have a 55 Ford Fordor Sedan. Are these the correct emblems for this https://www.fordbarn.com/attachments/284601/

I have a 55 Ford Fordoor Sedan. Are these the correct emblems for it his car?

I have new tie rods, upper control arms ,etc on my 55 Ford. I also have a 302 with C4 ******. New tires and alignment. I have checked the brakes and they look good. Also have a brake booster. Problem is sometimes they don't work all that good. Some times when applying brakes they don't...

First off, thanks to those who helped me with my distributor problem. My question now is hopefully not a hard one. The vacuum advance on the distributor of 302 engine has 2 places for vacuum lines. I have vacuum tubing on the center port going to carb. The port that sits on the top side of...

I have a 1955 Ford. Has a 302 engine in it. It has been switched over to 12 volt. We were going to change it over to an electronic distributor. The car has a voltage resistor that is changing power to the coil from 12 volts to 6 volts, even though the coil is 12 volt. I asked a mechanic...

I just installed a new drop in electronic distributor with separate 40k coil and new plug wires into my 302 ford engine. I believe once I was told that you need to match the type plugs to the new distributor. What I am asking is this: 1. What brand plugs and plug number. 2. What gap. (45...

Can anyone help to decifer these numbers for my 55 Ford. U5RG-130107 Next number is 73B KE AU 24 C 6883D If not, where can I find the information to lookup. Thanks.

I have one cracked glass on rear door on my 55 Ford Sedan and need to remove the cracked glass and replace it. I have the handles and panel off but not sure how to remove the glass. On Chevys I have replaced the glass and did not have any problems, but not sure on the Ford. Are there any...

I am getting ready to replace upper control arms on my 55 Ford. I ordered the control arms and they look the same as what is on my car. Except, only difference is that the old arms have one inner washer located at the rear of the control arm. This washer is on driver and passenger side with...

Can anyone identify what rearend this is.

I just removed the antenna off my 55 Ford and cleaned it up. It did not have an antenna wire attached to it I cleaned all the parts at the end of the antenna that goes down through rear fender I was wondering where I can get a replacement antenna wire that will fit the original antenna and...

The person I got my 1955 Ford from has made a lot of wiring problems. I have fixed most of them but still having one problem. The car did not have a NSS so I ordered and installed it on my C4 ******. I located a yellow wire that went from the ignition switch to the started solenoid so I...

Working on my shift rod and noticed a problem. I have a C4 with a column shifter. Can't seem to get the shift lever indicator needle on the column to match the gear that the ****** is in. When I tried adjusting the needle to match I discovered for example when it is in Park and you let go of...

Today I cleaned the underside of my 1955 Ford. It has a C4 ****** and a 302 engine. The car does not have a neutral safety switch and will start in any gear. The code on the passenger side cover on the ****** has a large A with a code underneath that which is C6AP-7D027-C. I think this...