Search results

How much should I add to my cooling system in order to remove the oil and grease buildup? Yes, I will be driving it..

I need to get an exhaust manifold heater. I have an autolite waffle style on my other car, and i'm not really impressed, even with an added sheet metal 'scoop' mounted on the front. This new A has never had a heater before, so there is no problem with inlet alignment. No, it's not for the...

I've lost the phone number of the guy in Houston that sells A/C kits for Model A's. I thought there was a recent thread about him, but search was unable to find it. Any help with his phone number and name would be appreciated.

Is there a suggested torque value for them? I thought I read 60-65 ft.lb. TIA. Walt

Do they work with our wire wheels?

It would seem to me that for other than fine point cars, they could be short-lived in daily drivers due to the ageing of their internal "chemistry" . Thoughts?

For those of us that run the Nu Rex modern upper plate, it might not be a bad idea to pick up a spare condenser to keep with your car. Mine failed after only 700 miles.

The condenser in my modern upper plate went bad. When I go to NAPA tomorrow, what car uses the same condenser as the Nu Rex upper plate uses?

With only one wheel off the ground, it takes 1 7/8 revolutions of the engine to turn the one rear wheel one complete revolution. I have a suspicion that I have a high speed rear end, and I need to know before I install an overdrive and Mitchell trans which is overdrive in 1st & 2nd gears. If...

I have a small panel with 2 LEDS in it for use as an indicator for my left & right turn signals. It has been set up for 6 volts. What resisters can I use on the left & right signal inputs to cut my 12 volts to 6 volts. Current is miniscule.

Does anyone know if there's a 60 amp ammeter THAT WILL FIT IN OUR INSTRUMENT PANEL?

http://www.youtube.com/embed/POXqGsgAtaY

Anything special to timing one? Also, what is the total advance?

In my new-to-me '30 sedan it seems like the axle ratio is not standard. At 60 MPH the tach indicates 2750 RPM, and the speedo is 6-7 MPH slower than my GPS. Also seems to go faster in 1st & 2nd gears, with a typical shift to 3rd at 30 MPH. What say ye?

They say there's no internal resistor, but does it need an external resistor? I wouldn't think so, or then I could just use my 6v coil with a resistor.... Could use some advice here...

OK, i've got the alternator, battery, all replacement bulbs, 30 amp ammeter, voltage dropping resister for the horn and 12v. coil. Is there anything I'm missing, and anything special I have to do other than install what I have? I'm putting in a hidden stereo system and air conditioning in my...

Prefer an authentic restoration, a retired fine point car would fill the bill. No junk, I've seen enough of that already. Reply to. Ikingbee1@aol.com

Have noticed there's a number of types of autumatic spark advance. Any opinions on which one/type gives the proper amount of advance, is adjustable, if needed, and of course, dependable

Under what conditions can that unit be shifted? Standing still, cruising, coasting?

http://www.youtube.com/watch?v=BLyJme8qL84&list=UU2P9t-lpJ2kHWWsM8Ujo8Kw&index=1&feature=plcp