Search results

Are you looking for the fuzzie in the door flipper molding? or the whole stainless door flippers? If you can post a pic of what you are wanting. Thanks

Anyone know of someone or place to rebuild or get a new power window motor for 63 1/2 ford galaxie 500 xl. Rear quarter window with coupler no gear. Thanks Tom

I am looking for a set of 2dr hardtop scuff plates. Thanks

here are some pics

Any comments or suggestions before i start to install the interior on my 56 ford victoria 2dr hrdtp that what help with install would be great. I purchased a kit from concours that is made by larrys t-birds. Thanks Tom

I put an FE 390 in the car and dont have clearance for the original linkage. Was wondering what some have used and their opinions on how it is. Brand and model would be great info to. I have looked at the lokar models but havent seen used in a 55-56 ford.

what have some of you used for aftermarket throttle pedals on 55-56 ford cars? Thanks

restoration specialties said they have the right fuzzies for the car. You need to trim them to fit and remove the bottom edge to show the little tabs then they slide right in. I tried this and when removing the bottom edge you have to be very carful cuz the tab will break off. I did one side...

scicala is correct!!

Has anyone found a vender for replacement cat whiskers/felt for the upper quarter window? This is the part that the window slides up into fixed to the roof line. Also if there is a video for doing the repair? Thanks Tom

I have a right and left fender for 56 for car. Both are in good shape. $300 each. Thanks Tom 715-927-5217 Also other 55-56 car parts

The difference in the shock could be that the shackle is flipped the wrong way in the rear. Lots of guys flipped it down to make the back end sit higher.

The tremec will fit but is bigger tha the top loader. It comes up higher in the center and on the driver side. Make sure you have plenty of clearance on each side to make it fit. Depending on the input shaft lenght might have to have the short shaft kit installed also. I was going to put a...

looking for a good possible show quality grill for a 56 ford fairlane.

Looking for a 56 fairlane trunk emblem. I have the Vee just need the plastic insert. Dennis carpenter doesnt know when they will be making any more. Thanks Tom

Yes its the top trim. Thanks for the info Racerron. I will see if I can find the clips.

Can anyone tell me how this trim attaches to the roof? It runs above the drip rail from the windshield to the bottom of the rear window. Thanks...

I am looking for a set of 55-56 mercury tailights.

Where can i get a stapler that will punch through the steel inner fenders to install the weatherstriping on 56 Ford fairlane? Or what have some of you use to install this?

custom plating doesnt do the bumpers they send them out. looking for a place that does them in house.