Search results

I have for sale, the front axle from my hot-rodded '30 coupe. 150.00 shipped to your door. 662 415 7698 or jbrowngunmaker@yahoo.com

I bought front and rear quarter patch panels from Macs. Shipment was fast. I did receive two right hand cowl panels. I called and they said they are shipping the other one tomorrow and to keep the wrong one. Customer service is important to me. As for fit of the panels, looks ok to me.

Charlie, A little more research shows I probably have a 46 Ford front axle. The wishbone mounts are the same at 2 1/4. I looks like all I will need is a longer spring. Thanks for the info.

I have have. the original axle under my '30 Model A that is fairly straight. I bought an axle that I thought was a Model A with some drop. My axle is about 50 inches kingpin to kingpin and 36 inches spring eye to eye. The new (old) axle is about 50 1/2 Kingpin to kingpin and 41 inches...

The previous owner had pop rivited a panel over the entire bottom panel. It covered up a mess and was a mess itself.

Randy, I found them. A bit pricey. I may have to use my ends and fab up the middle. LOL My ends are ok, it's just the middle that's a problem. Thanks again.

Thanks Randy. I appreciate the help. Looking at Brattons now! Jackie

Sorry about the stupid description. Been a long day. here it is, across the bottom.

It is on a '30 coupe. It seems to be just a cover over the end of the inner frame of the trunk. It's directly under the panel under the trunk lid.

Fellers, What is the strip of metal below the rear body panel below the trunk or rumble lid called. It is a 'U' shaped piece about 2 1/2 inches wide. I need one and can't find it listed. Jackie

Thanks Tom. I'm a muzzleloading gunmaker by trade and I made the top wood pieces from maple gunstock wood. Now I'm anxious to get it painted so I can try the vinyl top. I think I can do it.

Not exactly like sto' bought but they'll do!

Ursus, thanks! That's exactly what I needed to know. I made the header yesterday and one side piece. I just wasn't sure how much bow the slats needed. Thanks again.

I'm replacing the cross slats in my '30 coupe. The original ones droop down. My question is, how much ,if any, upward curvature do they have? I can cut my own with no problem if I know how much curve they have. I know it's a hard question to answer with a definite amount but i bet somebody...

Re: Model A parts SOLD All parts are sold except: I have the front mechanical brakes complete with new shoes, internal parts, new kingpins, spindles, ready to bolt on and run. 200.00 plus shipping. I also have a Stromberg Idustries Vacameter vacuum guage. 25.00 plus shipping.

Re: Model A parts Jeff, sorry, the runningboards were junk. Jackie

'30 Model A rear end complete hub to hub. Was driven last week. Will have to be picked up, can't ship. 662 415-7698

Thanks Fellas. the deed is done. Wasn't a problem. I have the body off the frame so everything just slid right out.

Thanks Joe. I have everything loose but didn't want to pull until I knew if anything was holding.

Fellers, One more question! Can someone give me a quick tutorial in removing the engine and trans together? I have removed the two halves of the front U joint cover. Does it slide apart now? Haven't lifted the engine yet and don't want to break something. Thanks Jackie