Search results

Greg, Here is what I did and it worked out well. Lay the switch panel face down. Pry open the tabs to disassemble the switch, cautiously. Carefully, lift off the cardboard contact panel. Photograph the copper rings of revolving contacts before removing. Lift them out and you may want to...

Doesn't sound like anyone has restored a visor before. Thanks anyway....

Very nice work, your'e on your way. Working with Ash is quite rewarding. I made ALL my wood for my '25 Coupe. Good luck...

Happy Thanksgiving! I'm restoring the visor for my '25 Coupe and all I have is the metal frame. Is there a filler that goes between the layers of covering before you close it up? Thanks...

Would anyone know what kind of wood was used in making these boxes? Thanks a bunch....

Thanks Guys, The complete illustrations were just what we needed for part numbers. Cheers...

Dose anybody know who made the 4 speed transmissions and is there a parts list available especially for the intermediate out put shaft.

Just acquired a perfect oil can. What is a common way to construct a holder for mounting in the engine compartment. Any suggestions or photos, please?

Thanks Jack...

Question for the experienced. What is the ideal tire pressure for a '25 Coupe with 21x3 1/2 Split rim tires? Thanks...

Thanks again to all. I do believe I have too much wear clearance in the pan ball socket. The springs on the ball studs are bottomed out and I detect movement when forcing with a large screwdriver. Cheers :)

Thanks a bunch guys. All your suggestions have good logic. I look forward to performing each one, one at a time. I want to see if I can learn something and assist others. Cheers...

On occasion, I experience a front end shimmy or wobble after a right turn only at low speed. Close the throttle and the car recovers. Any ideas where the problem cause lies? Thanks...

I believe I read a post onetime where it was suggested to add 1qt. Of ATF could be added to the crankcase oil. What does this do for the engine or transmission? I would like to learn the benefits of this trick. Thanks...

My '25 Coupe has that problem. I shimmed body the 1/2 inch mentioned. That fixed the hood fit but caused my hood latches to be too short. Had to countersink hood shelf wood deeper to get proper latch length and tension. Good luck... Racemo

I'll bet the advanced timing will be my fix. I'm new at driving and I've been pulling full advanced timing after the engine starts and leaving it there. Now I understand the bucking. I should have known better. Thanks all!

If low and high bands were a little too tight in adjustment (dragging) would that cause a severe jerking hole going from low to high speed? Thanks...:)

Thanks guys, Now I have plenty of information. I was contemplating adding LED turn indicators that are rated 9/12 volts. Would like to use LEDs at 6 volts but haven't found them yet. Thanks again...

For those who have done it...What is a reliable and economical method of making the conversion? Thanks to all...

Are there complete kits available to make this change? Have you experienced conversion. Thanks for any information and bewares.