Search results

I'm looking for a late model valley cover(must have1.25 hole for pcv grommet).these came on 1964'and up f-100s.thanks.

I have a 56 Victoria that I just rebuilt the 292 and want to ditch the draft tube and go PCV.WHERE CaN I GET A BLOCK OFF PLATE? Thanks

Looking for a Y block valley pan that has pcv. Thanks?

Any recommendations? Thanks

I tried to move my 56 Victoria out of the gay in neuty but it wouldn't move,so I dropped the driveshaft still nothing,I'm thinking the rear brake shoes might be over adjusted! I will try again tomorrow.

im missing my drivere side exhaust manifold for a 56 fairlane 292.Thanks

Who makes them?Thanks I have misplaced (lost) my driver side exhaust manifold . May as well as go with headers at this point.thanks

looking for SBF engine for a 56 vicky project.thanks

Ok i bought a 56 Victoria from an old gentleman in 2015 out of Henderson Texas.He said he rebuilt the engine.I pulled the valve covers and heads are clean as a whistle.I prelubed the cylinders with MMO.I put a 13/16 socket on the damper bolt and with a long breaker bar cant budge the...

I have a pair of rust free mint fender skirts I'm not using.They are 200.00 plus shipping.Thanks

Any good machinists in NJ FAMILIAR WITH THE Y BLOCK? My 56 is ready for a rebuild. thanks

Does anyone have the part # or know we're I can purchase the clips that hold on the SS HOOD LIP MOLDING? THANKS

I'm looking for a 61-62 Ford GALAXIE hood. thanks

Tried the search function.It wouldn't open.Im looking for options on the 56 Ford car . thanks and MERRY CHRISTMAS TO ALL BARNERS!

I'm looking for a rust free hood for a 1962 Ford Galaxie hood thanks.732-241-0033.

I lost the 3 little screws in the distributor for holding the points (2) and 1 for the condensor during my dizzy rebuilt .Will gladly pay asking price.I tried HDW stores. But they had nothing that small.Thanks

Hi Fellas in restoring a 60s autolite distributor I misplaced the screws for the points and condensor .Can anyone help me out?Glad to pay! Thanks

whats the best way to approach this.I know the SS molding is imbedded in the rubber gasket.Should I poke a hole and use piano wire cutting thru the rubber?

Ok ,I replaced my starter with a Robb MC starter and after it would crank but not start.No problem starting before starter install.Every time I go to start the red with green stripe from the ign switch C terminal which goes to the I term on the starter solenoid on the fender BURNS UP! will call...

I replaced the ignition switch in my 62 galaxie 390 and installed the bezel so "off " is at 12 o clock "acc" at 11 o clock and "start at 3 oclock just like it was.I cant get the lock cylinder to stay in place.Do I need the paperclock to install it?? Thanks