Search results

Pair of '35 rear axle housings (48-4010, 48-4011). Good bearing surfaces. $100 plus shipping for the pair.

I'm looking for my '37 pickup, which I sold in 1992. CA license plate 74748U. Sold it to a Model T guy from the Sacramento area who wanted a V8. Any leads greatly appreciated.

https://www.facebook.com/groups/1042177165834696/

Has anyone received theirs yet?

The next time you have your flathead-powered Early Ford V8 out on the road, climbing a long 6% grade at highway speeds, and you start worrying whether it’s tough enough for the job, just think of this picture of a 1935 Ford 1 1/2 ton truck, hauling two giant old-growth Douglas Fir logs, deep in...

Does anyone know of a source for rebuilding a '35 Sparton horn? Tuning no longer works. The best I can get is a pathetic bleat from one and nothing except a click from the other.

Has anyone here on the 'barn successfully installed a set of Bob Drake's cast iron headers on a 24 stud block in an otherwise stock '35 Ford which still has its original steering box? The tech adviser at Drake's says "...they should work", and I'm tempted to order a set on that semi-assurance...

This thread is related to: http://www.fordbarn.com/forum/showthread.php?t=158319&highlight=driveline+ticking Weighing all the good advice I got on this forum, I went ahead and replaced the worn pin referenced in the above thread with a No. 8 hardened bolt and nut. This repair occurred as I was...

Wanted: '35/'36 Rear End with 3.78 gears for rebuild. Prefer Central/Northern California location so I can pick up and avoid shipping costs. PM with details. Thanks.

Is there one? Any experience with their work?

Yesterday here in Sacramento, it was 79F. After a long run on the freeway, I parked my '35 in the garage. Five minutes later, I noticed a distinct gasoline smell and checked under the hood...fuel was leaking out around the throttle shaft and I could hear the gasoline percolating in the float...

What is the best 12V electric fan setup for a '35 Ford with stock radiator?

1. Who sells the best 6 to 12 volt conversion package? 2. Do Mallory electronic ignition systems care if a 12V system is positive or negative ground?

Who makes the best for a stock '35?

Has anyone had experience with replacing the pin that locates the driveshaft to the pinion shaft? It seems the new pin I have is a very loose fit, when it should be a snug fit. Does it snug up when the end is peened after installation? Does it matter?

Is there anything that needs to be modified in terms of motor mounts when installing a 24 stud (specifically, a 29A) engine in an otherwise stock '35? Are the u-shaped risers necessary?

My '35 (stock drivetrain) has developed a "ticking" noise when I let the throttle off. It's not the engine (not RPM sensitive and makes it even if the engine is shut off). Not a bearing noise. Makes the same noise in all three forward gears (although most prominent in 2nd and 3rd). Obviously...

Anyone know what's going on with John Edwards at Costa Mesa R&D? I've been trying to get in touch with him about a Flathead V8 rebuild and am having no luck. His phone doesn't get answered, voice mail box is full, and the contact email address box shown on his website returns an error...

Wanted: NOS '35 Speedometer; would prefer Stewart Warner, but will consider Delco or Waltham.

My '35 has an inline fuel filter consisting of a glass tube with chrome ends and a cartridge element. There are no detectable fuel leaks anywhere along the fuel line from the tank to the pump, yet when the car is running, there are bubbles visible inside the filter, as if it's sucking air from...