Search results

Having an issue with my amp gauge. I replaced the wiring from the generator to the regulator, they were toasted, well kinda, just hardened and loosing insulation. The amp gauge shows no charge or discharge, before or after I replaced the wiring noted. I actually installed, temporarily, an after...

I've got a nice rebuilt 94 carb on my '52 Customline, borrowed from my brother till I rebuild mine. Had it on before and it worked great, gave it back to him to try and determine some problems he was having on his '41 PU. Now I've got it back and it has the loudest whistle you can imagine. I'm...

Does anyone have a safe process for removal of the windshield on a 52 Customline? I have found one locally, it has the chrome trim, which I'm not going to replace. Is the best process to cut the rubber from the inside to gain removal?

Well I got the seal and bushing out of my '52 Customline. Bushing should be here Thursday, looking at the installation, how far into the tube should it be installed? I assumed there would be a shoulder to stop it at its' finished location, but I do not detect any. bbrocksr gave me a "tool" to...

Well my frustration level is at about a 9.9. I have another thread asking for input as to how to remove the seal at the tail shaft/spline end of the transmission. I replaced my u joints and thought it only made sense to replace the rear seal, wished I'd left that alone. Tried all of the things...

I'm in the process of servicing the 3 speed std. transmission on my '52 Customline. I've drained and refilled the trans and diff., replacing u-joints and have a new seal for the output shaft. I'm having difficulty finding an appropriate tool for pulling the old seal. I've got a slide hammer but...

Can anyone tell me the refill capacity of the std. 3 speed transmission in my '52 Customline? I want to drain and refill, but want the gear oil on hand when I drain it.

Now looking at a '52 - 4 door sedan, no motor or trans. I've been told it's not a big stretch to go ahead with putting a later model (239, 272, 292) OHV motor into one of these. Same 3 speed trans. Looking at this possibility based on cost and availability. Any input would be appreciated.

Looking for sources for floor patch panels for a 54 Mainline 2 door Sedan. Not having much luck searching here or the net.

Looking at a '54 Mainline 2 door sedan. It has a 3 speed with OD and a weak 239. I have access to a pretty nice 272 ECG that's been gone through, would that motor bolt up to the transmission in the '54? I've searched the forum but can't seem to use the correct phrasing to get the information I...