Search results

Looking for a used 52 Ford car sill plate for a 2 door Drivers side. Ruined mine getting a stuck screw out. Ocala FL 34481

Tomorrow I’m going to replace the drivers side front wheel cylinder for the 4th time in two years. These are purchased rebuilt wheel cylinders. I get about 6 months. What could be causing this? The other wheel cylinders are fine. Stumped

I have a 31 Tudor with F150 transmission. Everything was working fine till I decided I wanted to replace my speedometer. I received a different rebuilt speedometer back and I put a new cable from the Model A Medic in. It was fine for a couple hundred miles then the speedometer started jumping...

I have looked at this for many years. Never seen a complete one. What I'm interested in is the instructions to make this work. June 1950 Poplular Mechanics Three-Color Stop Light Signals Driver’s Action “Motorists following a car equipped with a three-color stop light know exactly what the...

I bought 5 tires from Cooker. The tubes they sent me are #864001. After an extended phone call he admitted those tubes are heavy duty (as stated on box) and not radial tubes. It appears they have quit selling radial tubes. 475/500-19.

Anybody have a breakdown on how this is put together. I came across a set of chrome rings, but not sure how they get attached.

Does anybody have something on installing the front window on a 35 Ford 4 door car? Looking for a step by step procedure.

Is there a reason why I can't put the late 31 sediment bowl on a 30 carb. I know the late 31 carb has the inlet in a different position.

Looking for the 6th from top Leaf on the front spring. It's about 20 1/2" long

Looking for a bell housing for a 52 Ford Car 6 cyl

About 8 years ago I put in a new clutch, pressure plate, throw out bearing and pilot bearing. Recently the clutch chatter was getting really bad. I ordered a new clutch, pressure plate, throw out bearing and pilot bearing from C&G Ford. I put that in and no difference. The clutch and...

I'm missing EAA-9449-A. Spring 1GA-9467 broke. Any idea where I can get these two parts?

My windshield fogs up when I put on the defrosters. I'm told this means my heater core is leaking. The Ford Shop Manual skips over replacing the heater core. Any idea where I start?

Can I use any BW R10 governor? Chevy, Studebaker, Nash, etc I'm guessing the gear would be different. I have two governors that look alike. One is TGE-4037 and TGE-4086. What are these numbers? Any cross reference books?

When I put on my low beams, both filaments light. When I put on my high beams, both filaments light. I unplugged one headlight from outside the headlight where it connects to the bulb. Took the switch apart. When I jump from the power to low beam and check the bulb end, I have power to both...

The big gasket on the rear end is leaking. Tried tightening the bolts but leaking again. Normally the gasket is to the rear of the car and just removing some bolts to change the gasket. Could not figure out from my 52 Ford service manual what I need to do. Can I just disconnect the rear...

A few months back the car started pulling to the left. The LF wheel cylinder was seeping. I replaced both wheel cylinders and brakes. Problem gone. Now a few months later the same problem is back. Car pulling to the left. Wheel cylinders not leaking. I replaced the rubber brake hoses...

This is a picture of the 53 Ford Pace Car in the Henry Ford Museum. 9,000 miles. Anybody know what that knob to the left of the steering wheel is?

My lock started getting harder and harder to turn to unlock the door. And of course I locked it and bent the key trying to open it. Now its time to get it fixed. I did get it unlocked and took it to a lock smith. The lock smith turned the key half way, inserted a pin and could not get the...

I have a late 31 Tudor. Years ago I had to replace the king pins. I remember the top of the model a king pins did not align. We put in 32 king pins and all was good. It would make sense that a late 31 could have a 32 front end. Saying that I understand there are two pins. A-2075 7.25" and...