Search results

It’s close to brake backing plate on axle housing . WHERE IS THE GREASE GOING..?

I ordered a pair of 32 inch window felts , but the groove seems too wide compared to my glass thickness. Do I just narrow the felt by hand . This is for my 30 4 door ts Drivers side back window Hope someone can help. Fredski

Do I have to remove intake / exhaust manifolds. I would rather not. I do have adjustable lifters , it a AER MOTOR,with about 800 miles on it. Fredski

Doesn't make a difference if gav closed or open . I adjusted it to 3/4 turn out only because it should be out some. Car starts and runs well as it is. Fred

AER engine with 2000 miles, 5.5 Snyder head which was recommended, Motor was run warm for 5 minutes.cyl 1 94 lbs. cyl 2. 90. Cyl 3. 91 Cyl 4 91. This on a non balanced motor. Anyway just wanted to share this info, and was happy with results. Fred

My dwell meter is fo 6 or 8 cyl. Can I use 8 Cyl mode and compensate the Reading??? Fredski

5 gallon can reads industrial gear oil. can I use in my transmission?? given to me by son in law which is used for elevators. fredski

Just received macs latest catoloug and was very impressed. Good pictures of parts and a lot of diagrams of parts as well. I think it is more informative than the other 2big guys. Fredski

I adjusted brush down and now can not get it to go up. I had no real reason to move it but now can not raise it. now it reads 10 amps on amp meter . very possible gen is original and never been taken apart. ?? fredski

Below hood clips and hood handle there is single hole Below these and wondering why they are there. Fredski

This happens only occasionally . Should I be concerned? What is the cause of this and how to fix if I do. Fredski

do I use search forums or advance.. fredski

right now I have original off to install a new one .. the sector gear is in place and I would like to pull out to clean out old grease. question is will I get it back in correctly , or can it only mesh one way? fred

okay all is in place and have snugged mounts that I can still turn bolts with wrench. do not want to over tighten so how tight should I go. did not use a torque wrench but guessing I got about 10 lbs on them ?/ thanks in advance fred The. Rubber donuts I'm talking about

1930 town sedan Canadian model. Have owned car sines 1970. This is vin on my registration and on Original when ibouhgt it. I thought vins would have same as engine stamping number? Fred ski

is this directional or can it go on in any direction. mine has to holes in the cup one on each side?? do not remember how it came off fredski

I bought these pads 25 years ago and have not put them on yet. if I do I will have to boil in water to soften to stretch on. where these factory installed?? fredski

what direction should it be in when light switch is in 6 oclock position doing this now any body help me out fredski

It came with the car which I purchased in 1970. Why the other end not fit my wheel lugs ??? The tire wrench End is smaller. Fredski

website not responding. I was recommended to order transmission kit there. are they in business still / fred g