Search results

does the top edge of inside door panel fit under window garnish, if so how much?

I have recently installed a rebuilt flathead in my 48 coupe where is the front lower heater hose support bracket mounted on cylinder head, which head bolt can I use?

I need to remount the heater hose support on my rebuilt flathead, it is attached to the engine head bolt(mine are nuts), can I just remove that nut without re- torqueing all the other head nuts?

On my 48 coupe some screws that hold dash panel around the speedometer are loose, I need to tighten them, but access to them is impossible. The only option I see is to remove the dash, is there procedure to follow, I haven't had any luck on the internet so far, maybe some member has done this...

Anybody with a 46 to 48 ford (or mercury) coupe, between the front seat back cushions I am missing the material to cover the seat frame at the pivot point. I am guessing that it was use to minimize frame exposer, its not a big piece, but there are hoses in the frame for attachment, a template or...

I need a complete hood dowel assembly, dowel, spring, and adjusting nut for my 48 Ford coupe

I am installing front door panels but I need bottom clip hole locations, could use the help THANKS

My48 has been sitting awhile but its ready for the road. I noticed today looking from the front of the body is leaning lower on the driver side, is this a front or rear spring issue, maybe shocks, could use some advice to correct the problem, just thought of another issue not related to the...

I pulled some pictures and installation drawings from the forum, but they are from 2010 and 2014 and are not clear for what I need. My 48 has everything but air deflector mounting to the hood is damaged I need a picture or sketch to show the mounting tabs required so I fabricate something that...

delete

I have a couple of questions: 1. can disk brakes be adapted to front & rear axles on 48 coupe chassis, if so what is a good set-up? 2. can the 8ab distributor be used on a 59ab motor

I am making my on engine run-up stand and need bolt pattern dimensions for bell housing to engine bolt holes (59 AB). I don't have the engine yet but I won't to get a heads up on the stand so I can be ready.

what flywheels can I use in 59ab motor?

I am having a problem reinstalling the rear seat in my 48 coupe. The upper part went in just fine but the bottom part just want install. I have tried different angles and then pushing back, no dice. The seats were out of car for over a year, could they loose shape at the rear portion of the...

I have access to a rebuilt long block 53 merc flathead, I need to know what it takes to install it into a 48 Ford coupe before I take ownership?

I am rebuilding 24 stud flathead, all studs were removed ( some broken) so they all need to be replaced, new stud kits are pricey, can high grade no. 8 bolts be used instead, stock heads are being used.

Does anybody out there have any information ( including photos ) about installing truck weather strip clips for a 48 Ford coupe. I bought kit from Drake with two clips and mounting hardware ( one in each corner near hinge). The package only shows location but nothing about using the...

I want to add ashtrays and armrests to the rear panels in my 48 Super Deluxe coupe but I don't have cutout info to make the attachment correct, I have all the parts. The existing side panels were blank, could use some dimension, I have several photos that show the locations, if any Barn members...

I recently posted a request for information regarding the location and mounting of the rear ash trays for my 48 coupe with little response.I did receive a post with locating dimensions, which I appreciate, but nothing on the mounting, is there a retaining bracket involved that would mount on the...

I need to locate and mount a pair of rear ash trays for my 48 coupe, can anyone offer mounting procedure, I know a cutout is needed but that's all I know.