Search results

My brake pedal does not match the clutch as far as the height when they are up. Was there ever a difference with later brake pedals as in 1932and up? This was like this when I bought the car and am wondering if the notch that matches with the bell housing might be the problem.

Does anybody have a good idea how much a GAZ engine head is worth?

Hi Guys. I need your help again. I wanted to build up a couple of distributors to carry in my car. I replaced all the parts with modern points and new lower plate with longer wire. The first one I installed worked perfectly, but the second one wouldn't start the car. When checking for voltage...

Does anybody know where I can get a blank model t key

I have a 31 s/w and the wiper arm came off the other day. My problem is that I can't figure out how to put it back together again. It is the arm, not the blade. Help please, pictures would be appreciated.

I recently acquired a brake lathe Star model #800 and I would like to rebuild my brakes. Problem is that no information came with the machine. I was a machinist for many years and know that I can do it. If anybody has a technical manual for this machine I would like to get a copy so I know what...

I just bought a 1931 Slant Windshield and would like to remove the piece that is between the windshield and the gas tank. It really needs to be repainted while the paint on the car is excellent. I would rather not try to paint on the car because the paint is so bad on this piece it would be...

What is the best grease to use on an original water pump?

I was having trouble timing my Model A so a friend of mine came over to help. After insuring that the distributor was in good shape and the point gap was set at .022, he set the timing so that when completely advanced, it was at 28 degrees. Car runs great now but was wondering what the opinion...

I have a 1921 Roadster and would like to install turn signals. Any suggestions? I see that Lang's has a complete setup. Is that best or should I purchase the lights separately.

I am trying to determine how many amps my starter draws when starting my car. I have a clamp on ammeter gauge and want to know how to test is. What procedure do I use? What should the starter draw during startup? My car doesn't start until I take my foot off of the starter button.

I see Model T's with and without what appears to be kerosene side lights. Is it proper to put them on if my Model T does not have them?

Am new to T's and was wondering what the physical difference there is between a 1921 and a 1924 T. I purchased a 21 Roadster and it has a 24 engine in it. Just wondering!

I am new to Model T's, 81 years old and it is tough to get down to check oil level. Is it worth getting the dip stick kit to check oil from under the hood? Have only had Model A;s for the last 60 years.

Does anyone have the exact dimensions of a 30 coupe door window glass?

I am installing a new u-joint and noticed that the inner cover that goes inside the 2 piece cover has a hole in it that is about 1/2 inch in diameter. My question is, where does that hole get positioned? At the top or side or bottom.

I have to repair the rear axle because the pinion gear has many teeth broken. Also the ring gear is damaged. My question is, I have a used ring gear with the same number of teeth and a good pinion gear that also has the same number of teeth. Can I put them together or do they have to be a...

What direction does the bearing race and the seal go for removal? Out the front or back? I have everything out including the drive shaft.

I was told that there was a way to stop the rear main oil leak by cutting a groove in the babbitt on the lower half and drilling a hole in the groove to drain the oil back into the crankcase. Does anyone have the plans for this procedure?

I was told that there was a way to stop the rear main oil leak by cutting a groove in the babbitt on the lower half and drilling a hole in the groove to drain the oil back into the crankcase. Does anyone have the plans for this procedure?