Search results

anyone buy woven riveted linings for a 36 if so where can i buy them thanks

changing the gears in the 30 a rear end 3.96 came out putting in 3.54 the gear is bigger on the 3.54 what has to be done on the rear end house to get the gears to work thanks Mike

I a 34 roaster with columbia rear end the car has all the right stuff for it but the valve for the vacuum on the transmission has any body found something to replace it with or is any one running with out it thanks mike

hi i have a 1934 roaster with a columbia axle i am looking for the vacuum control valve that is worked by the clutch or if someone has something that will work thanks mike

hi i have a 1934 roaster with a columbia two speed axle i am looking for a valve or something that will work for the clutch valve thanks

i am looking a good 1936 wind shield frame for my cabiorlet rust free thanks mike

iam looking for a good or new wind shield frame for my 1936 cabriolet is anyone remaking them or someone with a good rust free one thanks

I am putting new valves in my 36 the new ones are stainless replacement ones what is the best setting for these the book says 10 to 12 intake and 14 to 16 on the exhaust thanks mike

I have a 36 coupe I need to redo the trans I heard that you can put a newer set of gears in the trans does any body know what years can be put in the trans thanks the car is all stock mike

has any one tried the new 6 volt solenoid that shoe box ford sells

hi does anyone have plans for the front floors on a 26 tudor thanks mike

when in Hershey in bought rabbited rods from a vender a set of four so now I am ready to rebuild my motor had it bored 20 over now ready to fit the rods to the crank to find the rod and cap have not been cut at the new Babbitt do I just cut the Babbitt then file it down to fit or will I...

just picked up a 49 merc with 34000 original miles but it been rode hard and put away wet the shift arms are badly worn does a shifter from a 51 merc fit the 49 trans thanks mike

I am looking for a 26/27 left front fender in good shape mike1937@hotmail.com

where is the gas tank in a 26\27 tudor under the cowl or under the front seat thanks mike

its time to replace the clutch dics's i already adjusted them up but still slips i see jack rabbit and a 400 set in the parts books is one better than the other going to a winter need to get the parts ordered thank for any insight mike

i have a 51conver with an overdrive trans can the trans be taken out with out taking out the motor because of the x frame ****** needs two come out oil leaks at the shafts on the ****** thanks

when driving ih high gear i give it gas it seems to be slipping in high gear the car shakes badly if i go slow on the gas it will not shake how do i adjust it thanks

i have a 36 with the steel top fuel pump the gas is gone thanks to the new fuel we have to use and the rebuild kits out there the gasket fo the top of the pump is to same what are people doing for the gasket and the small seal under the bolt on the top will a 1946 glass bowl pump fit the 36...

witch is the best way to time the engine on the t i have a 26 t some say to measure after tdc i think it said 5/16 of an inch another was use a dial gauge after tdc go 91 de and set the time and rod when number one fires not sure witch one is better to use or is there an easy way to do this...