Search results

SOLD - Spare tire cover for 1936 Ford Coupe Deluxe, $300.00 plus shipping. Good condition, includes lock & key, chrome hubcap, new chrome trim ring, new rubber lock ring and cover seals. Livonia Michigan.

My 1936 221 cu flathead with a Stromberg 97 stalls when I come to a stop. I tried adjusting the float using the dry method by holding the carb upside down so the top of the float is level with the edge of the bowl, but that didn't fix the stalling. It runs great otherwise. Any suggestions?

Should there be an "O" ring or gasket installed on the oil pump where it attaches to the block of a 36 flathead? There is a circular indentation on the oil pump shaft where it slides into the block as if it's for an "O" ring.

Should there be a washer on the bolt/nut holding the oil pressure relief valve and spring in position on a 1936 coupe flathead? There was no washer when it was removed.

What's the going price for a 21 stud left bank head? Water pump at the front.

Could someone provide me with a picture showing the location of the body number tag for a 36 5 Window coupe? I have the holes in the firewall for the patent tag but not the body number tag. Thanks.

I’m attempting to install new door window channel seals in my 36 5 Window Coupe. The car did not have windows when I purchased it over 10 years so I don’t have much to go on as far as old parts to look at. However it did come with a new door glass run kit purchased from Tom Meyer V-8 Ford (dated...

I can't seem to locate a bottom seal for the rear roll down window of my 36 5-window. I have the replacement rubber/felt glass channel and rubber bumpers but nothing for along the bottom of the glass. Can someone point my in the right direction?

My 5-Window Coupe has what appears to be a windshield vent mounted on the left side of the dash. It has a rod attached to it under the dash to open and close the vent. Is this intended to bring in outside air? My problem is, there is nothing attached to the vent mechanism under the dash. What...

I'm assembling a 36 5 window coupe that I bought in pieces, and I'm a little confused as to the interior garnish. To be more specific, I'm not sure how the headliner and the overhead windshield panel (used to attach the sun visors, wiper motor and possibly dome light) come together. Is this...

How are the choke and throttle rods attached to the rod joints on a 1936 Ford?

Can someone give me the procedure for adjusting the mixture on a Stromberg 97 carb?