Search results

Picked this Mallory up the other day and cant find any info on it as far as wiring it into a stock wiring harness. I don't plan on changing from a 6volt pos ground system. But I don't know how to wire this into my stock harness? Wiring is not my specialty, can you shed some light on this for me?

Hello folks. Let me start by adding this is my first adventure in A land. I am getting started on my miller ohv conversion and I have a 350 cam from Stipe I will be installing. My question is, is the timing pin just used for finding TDC. If I want to pull the cam, should I line up the pin mark...

Converting an A model to juice. 540-875-9991 Jesse

:mad:Thought I found a intake that I could use. 2 issues that I have are that the intake slot for the gen is 3/16 larger than the gen. The other is the fan pulley is a 1/2 more towards the rad than the other pulleys. What gives guys I cann't find a intake that works.

I put a dual carb intake on my 35 and went to install the gen and it sits in the grove on the intake very sloppy. Measured the gen base it is 2 1/2 inches and the intake slot is 2 11/16. Nothing is worn out nice crisp 90 deg edges. I am not pleased with the fit between the two parts, does anyone...

I have a edmunds dual carb intake I would like to run on my 21 stud. Does any one sell a longer rod? Can I mig weld an extension or should I braze it?

In the pass side front of the pan is what looks to me like a bafffle or maybe an overflow. The oil level on the stick is about an 1/8th inch above the full mark and there is oil leaking out of this spot. Is this a overflow or do I need to pull the pan and look into this further. My experence...

Wired my 35 and I can only run one headlight with out blowing a 30amp fuse. It will run both for about 20 sec. Thought it may have been in one of the headight harness (short) so I switched lights from one side to the other but can only burn one. I do not have a radio or a heater. What amp fuse...

I lost your number Loyd and was wondering if you still had the 35 crank pulley.

I am in need of a 35 crank pulley 540 875 9991 jesse

:confused:I put a wiring harness in my 35 from mac's. I did not have any wiring in the truck before. It is wired to there diagram as well as vanpelts and others. The cutout seems to be working as it should opens at idle closes when rpm's increase. But when I hooked up the wire to the out put on...

It was time to go through the rear on my 35 p/u project, broke it all down put in axle seal's, packed bearing's, every thing went fine. Now onto the torque tube seal, the new seal stop's about 3/4 to 1" from where it should, there is a ridge behind the bearing sleve. Have any of you had this...

All most have my truck ready for its first drive in 40 years, I noticed that the drag link is very close to the wishbone on the pass side after installing it(about a 1/4") and it touches the wishbone when I jack the driver wheel up. Could some one tell me how to identify the correct one.

I'm in need of the drivers side spring perch on my 35 p/u. Jesse @ 540-875-9991

I have doors with glass and all trim(doors are decent shap). Bucket seats, tilt column with wheel, bumpers(need to be rechromed), hood, fenders. Lots of misc trim in good shape. I had to move these parts out side due to lack of space, dont want them going to waste. Hope somebody can put them to...