Any one sell a longer fuel pump rod?

[bedfordboys24523]

I have a edmunds dual carb intake I would like to run on my 21 stud. Does any one sell a longer rod? Can I mig weld an extension or should I braze it?

 

[charles in east texas]

I use leather in the fuel pump cup. Charles

 

[JM 35 Sedan]

Many of the Early Ford V8 parts suppliers will carry the different length fuel pump push rods.

 

[ken ct]

Depends how long you need it. There are 7 7/8" and 8 7/8" stock and some shorter ones below the 7" one. ken ct.

 

[joe plumber]

I welded one several years ago when I was a kid ,just used a stick welder and then ground the weld .

 

[Walt Dupont--Me.]

Measure the back of both manifolds, it's probaly one inch differance. If you need the long one 8-7/8 about all the part places have them Mac's ect. Walt

 

[Karl Wolf]

Some of the stock fuel pump push rods were three pieces, a center tube and two different length ends, I made a longer one by taking the shorter end out and stealing the long end from another rod... Put it together and cut to size. I do not remember what the possible length of this combo is...
Karl