Search results

I 've used the attached for conventional wired spark plug leads. Any suggestions on how to use it with the brass strip to #1 plug, or to another power lead to coil, etc ? It can be set for 4 or 8 cylinder powered by an internal 9 volt battery . The handle is squeezed to open the hole shown by...

Wanted original water inlet, Later design, no corrosion or rust thru or repro aluminum. Thanks

Would placing a right angle (down) elbow , perhaps similar to intake stacks on hot rods, etc., enhance air flow to a stock carburetor ? Was thinking to use an Air Maze without the screen, (which restricts air flow) in combination with stock engine pans. if there is empirical tested data, such...

Frame spread with F150 Transmission in stock A Frame I have a frame spreader that works fine for stock A transmissions, but it won't clear the top of an F150 type 4 speed. Any suggestions other than bottle jacking or prying against the alum. transmission case or stock bell housing ? This is...

Wanted: 7/8-18 threads new spark plug washers or where to buy.

2 cars with the following: 1. 6 volt 1.5 volt epoxy, stock head, 3076 plugs (proper reach), 12 Ga stranded copper wires from coil terminals, stock ignition. 2. 12 volt 3 ohm epoxy, h.c head. W18 plugs (proper reach), 14 Ga. stranded wires from coil terminals, stock ignition. Secondary wire from...

Is 12 Ga wire ok for the ignition to coil and terminal box to coil terminals ?

Can anyone recommend a quality repro on /off ignition switch that fits the '31 round speedo instrument panel ? Anything besides the Nu Rex Switch, please.

Does any one have at hand the spark plug hole thread depths for a stock A head and a Brumfield 5.9 head ? The stockers can be measured, but no Brumfield available to check. Thanks Gary.

Some suggest installing a short piece of fuel hose in the fuel line, firewall bowl to carb to prevent stress issues either end ? With or without (FAMS) Float A Motors, any thoughts without discussing the pros/cons for FAMS ?

Do the hood rods need to be removed to install these type of stays ? Does anyone have a photo ?

Attached are 2 options found for center main oiling. A. What is the triangular plate that appears to accept the pipe fitting and where the oil pump drops on to ? B.Is the oil line tapped in to the block side face and how does that accept oil from the galley ? (Glyptal painted block)

delete

Is there any method to raise up one low frame point (sag) without removing the body, etc .?

The big end nut that screws on to the 19-34 Speedo gear case split apart. Does anyone know where to get a replacement nut ? The cable is fine. Brattons shows the threaded end to be 7/8-18

Which gasket type is preferred, paper or cork ? Advantages of each ?

Wanted for fine Point: '30-31 cowl band. Can be steel or stainless but stainless preferred. Please private message

Bought 2 kits for undercoating fenders, only needed one. Fresh in box with rollers, unopened can.$100 at parts store. $60, no shipping. Site won't allow photo size. Can email . Pm please

How are the upholstery door panel ratchet nails removed for the pickups ? Should the grommet and nail be removed as a unit ? The vendors sell these to replace the originals that were mounted in metal retainers no longer available.

Inherited a 2 blade alum fan / water pump. The fan won't come off the shaft with a puller, etc. Any safe method to remove the fan so as to not damage the fan ?