Search results

Old Rusty, as my wife calls it, is my plow truck here in Mi. Runs good for a 400 $ truck, except when it warms up. Its wierd, sometimes, not always, has a big bog when stepping on the gas, then quits, starts right back up and runs good for a minute or two, then does it again. I changed the in...

Any advice for a disc brake upgrade on my 64 tbird

has anyone done the pan seal on one of these. Looks like the motor may have to come out. thanks in advance

Not only did ford make great cars in 1935, but it is the first year for beer in cans.

I have a 255 merc in my 35 coupe and would like to lower the front a little, my pan now is the center sump and I was thinking the rear sump would give more room for tie rods. But, no room for the pan, front cross member is in the way. Any ideas? thanks in advance. Paul

Looking to change the front of the tbird to disc brakes, does anyone know what year and model spindle I need. thanks, Paul

I bought a dual master cylinder to replace the original single master. Looks like all will work but the brace to firewall needs to be raised or something. Any one done this? Thanks in advance. Paul

I see one for sale with suicide doors and car front end, rhd, 4 cyl. where did they make one like that or is it a homebuilt. looks original. Paul

This is original steel pan for 35-36 pickup floor. Covers the brake and clutch area and over the transmission to passenger side. I bought it thinking I might be able to use it in my coupe. Solid, with surface rust. $75 plus shipping. Thanks

Looking for a master cyl upgrade that will fit my 64 t bird. Still has original drum brakes all around. Has anyone used a newer dual master with any luck. I would like to keep my original booster, but I would feel safer with the dual master. Thanks in advance. Paul

Last winter when I stored the 35 I did not depress the clutch and in the spring when I first started it The clutch was stuck to the flywheel. So now I am thinking about putting something to hold the pedal down, like some on here suggest. Are there any problems with the pressure on the throw out...

Looking for the mounting brackets to install lovejoy shocks on the rear of my 35 coupe. Thanks

Just asking if any one has had good success rebuilding the vacuum wiper motor like whats on my 35 coupe. Or am I better off replacing it with a 12v motor. Thanks in advance, Paul

Looking for a header panel for 35. I have a original old stock muffler for 35 to trade. also other parts, some new, some used. PM me. Thanks Paul

Just finished the floor and put on the scuff plate, looks good but the door don't have enough room to close, only goes on first latch. Door closes good without the scuff plate. Anyone else had this problem? Thanks in advance.

Is this the proper spring for the front of a 35 coupe, seems mine sits to high in front and I have seen other springs that don't have extra leaf that wraps around the eye. The spring has 10 leaves. Thanks in advance. Paul

Looking to buy set of front and rear lovejoy shocks for 35 coupe

Any one have a supplier for the larger size goose neck for the later flatheads, mine are about 1 inch ID and I am looking for the larger diameter. Thanks in advance.

Ok, I got a new front drive shaft bearing and shell and seal. Installed the seal no problem, installed the bearing shell correctly with the dimple aligned properly. The bearing goes in the shell nicely untill I put the driveshaft in, then there is no way In fact I slightly bent my new bearing, I...

I am questioning if my original 35 radiator has the capacity to cool a 255 merc engine bored 60 over. If everything else is right. Thanks in advance