Search results

What are the differences of the lower deck lid panel between the coupe and roadster? I see repair panels are different. I need the height of either or both coupe and roadster please.

Looking for a left reinforce brace for x-member 1932. I also need the rumble lid hinges cast with numbers B-47430 and B-47431 for std. coupe.

I need the left leg brace for an original mid crossmember and did a google search. A couple of folks advertised that they make them but they have disappeared. Anyone know of repro`s of the originals out there?

I can`t seem to locate an Alemite grease gun with a good to decent bright finish. Anyone have experience taking one apart for plating OR? Looks to be cadmium satin.

Repairing a crab cap distrib and the first thing I spotted under the cap was the broken copper connector between the 2 points and the brass post for the hot wire. This is made from .010 copper sheet. Not impossible to find but to replace the rivets etc and insulation seems excessive. Anyone have...

I am looking for this extension bar. Has the 1/2 round end.

I am just finishing up a collection of the included Ford tools with the 32 and just found the cast and forged ASMC jack. This was the "Other" jack as shown in the 32 book. I have been watching for one for a couple years and the very good as found unrestored jacks are green and not black. The...

Need 1 or 2 Columbia Deluxe whitewalls 6.00x16 in good condition.

Anyone have the dimensions of the B-7118 and B-7121?

I have lived with my 32 5w with rumble lid too low at the rear sides when closed and finally removed it to investigate. David's wonderful 32 book shows the roadster hinges and gives part numbers. Well I have roadster hinges on the 5w and I bet that is the problem. What are the correct part...

I have been checking the suppliers and all seem to sell the lower 1/4 patch but only sell in pairs. I only need the drivers side. Anyone know of a supplier selling just the left?

I am using a brake hose with 3/8-24 inverted female threads and can`t find an adapter to the female T- block also with 3/8-24 inverted thread. Any ideas? Thanks

I have these ford windshield hinges but not sure of fit. Not 32 coupe. Please check these measurements against what you have please.

I have a starting crank extension and it measures 23 1/2. I have had it for years and came with a 32 V-8. The book says I need the 16 3/4. Any ideas what the 23 1/2 was for? Thanks

Anyone know the year and if Ford of a 2 piece folding jack crank that is 46" long and 3/8 shaft dia.? It looks like the 32 ford crank in design.

I am looking for the lug nut/engine starting crank and the matching single angle shaved extension shaft. This is shown in the 32 book and not the four sided taper style. Private message me if you might have. Also 32 jack and 2pc. jack handle.

looking for a 32 jack. stamped steel shark fin style. thanks

I have my shark fin jack (stamped steel and riveted together) taken apart for restoration and found what looks to be a stamped bit of light sheet metal similar to how a seal is constructed. Maybe a spacer for the vertical shaft as it was found in the base. It is mangled badly and exact shape is...

I have checked the "search" and also google and no true picture of a 1936 intake manifold. I can`t seem to find one close so getting a date from underneath it is not working either. Has anyone got a good pic of a 36 intake please? Thanks. The distance from the center generator bolt to mating...

Looking for mid-40`s intake manifold for my V8 #C11A-6520-C. Please Private message with price and a picture if you have one for sale. Thanks