Recent content by Sly

...its june 1928 ..but not realy sure of the month..

Does anyone have an idea? Is that normal that you have to cut the new brake rod at the thread to make it fit? new lengths is 50,98 inch

Hi Jerry, here are some pictures...

Hi jerry The brake rod os 50.98 inch...is that corecct More later

Hello, I found that my new brake rods are to long, it seems?! I turned the fisheyes till the end but the thread of the brake rods are to long. I have neary no brake power. I have new brake shoes implemented, the inside of the drums is fine everthing works. Is it normal to cut the threads of...

Thanks Marshall, another question as I found different length of springs in my tie rod / Drag link. I also ordered new at snyders, but these are a bit longer than mine. Do you know the orignal length of the springs in the tie and drag link? Are the spring in tie rod and drag link the same...

Hello, if I am going to assemble a new tie rod, would I have to turn left and right tie rod ends the whole way to the end of the both threads of the tie rod? I am asking because ot the following wheelalignment. BR Stefan

...thanks Keith!

Hi there, does anybody know the exact measurement (length) of the: Brake adjusting shafts, located in the drums? Best regard Stefan

Hi there, does anybody know the exact measurement (length) of the: Brake adjusting shafts, located in the drums? Best regard Stefan

Hi, does anybody know the exact diameter of the top pin (which goes into the clutch) from the Main Drive gear - new part - (please see attached picture)? I need to check if my one is to much worn or not. Thanks in advance... stefan

Hi all, I found the main problem, the float bowl has been soft solded. The weight of the bowl therefore was different. I should have thought about it before. BR Stefan

I am using my Model A with B Head and B waterpump; Do you think the makes it neceassary to special spark plugs? Does this combination needs a special ignition timing??? What is the right heating value if you mostly drive in slow traffic? BR Stefan

...another question: I have two different needles and needle housings and I am not sure which is the right for my Tilloston, please take a look at the picture; it is measured in cm...

Thanks for your fabulous information and pictures. I think with that I will solve the problems. BR Stefan