Recent content by My 34 Ford

A short note to thank all of you in the Ford Barn that have helped me find the few missing parts I needed to complete this frame off project. I also want to thank the Barn for all of the good advice that has helped me solve many of the problems I encountered in my efforts to put this car back...

What does the number 40-6049-A2 cast on an Aluminum head mean? Can you tell from this number if the head is for a flat top piston or a dome piston? Thanks

Just use a pair of long nose plies to put the retainer in place once the guide is in position.

You got it. Seals on the intake only if you put them on the exhaust you will never get the guide out again.

Hello, I am looking for a 1934 fuel pump stand and cap for a 21 stud engine.

Hi, Do you still have this? Is this a 3 bolt body for a 3 bolt coil. Thanks

Let me give you my imput from a guy who is looking for parts to finish a project. By far most people here on the Barn have been very helpful and I have had good luck finding and buying some of the things I am looking for. I have found a few people here on the barn that it is impossible to...

Len. Use composition gaskets on Aluminum heads. Best gasket 507G is what I am using. No problems. I learned this the hard way. Used copper first and had to take them off as I could not get them to seal, a lot water went out the tailpipe with the copper gaskets and Aluminum heads and the...

The original front fenders on my 34 are rolled. The 34 five window I had years ago had rolled front fenders and the extra 34 fenders I have are also all rolled. In fact all of the 33 34 front fenders I have seen had rolled edges.

Hi, looking for a 34 or 35 flywheel. Thanks

Hi Walt, Thanks for responding to my 34 flywheel question and how to tell the difference in the flywheels. I only have the 11 inch flywheel and so I have nothing to compare the difference size rings to. I am hoping you can tell from the attached photo and tell me if I have an early one or a...

You can also go go bestgasket.com on the web. This is the best casket for aluminum heads. Use them on my 21 stud with aluminum heads.

Thanks Walt. Is there any way I could tell what year 11 inch flywheel I have? Are the 48 and older thicker than the later years? My flywheel is 1 1/8 inches thick.

Are all flywheels created equal? I know that 32-34 use a flywheel like the Model A's but will flywheels from other years fit on my 34 21 stud engine? I have an 11 inch flywheel and have been following the comments on the barn about drilling it to fit a regular 9 inch car pp and disk and wonder...

interested in 34 intake manifold. Do you have photo? What is condition? Dennis dscheibe@cox.net