Recent content by dcnner

I have broken studs flush myself, and succesfully pulled studs out of four blocks ( few by some standards). The method I use with success is heating the upper half red hot with a torch, quenching with a block of petroleum wax at the block. Fire and smoke----however when left to cool, the studs...

I purchased a model 40-187 Bear engine analyzer, which is similar to the Marquette. I am looking for the operation manual, or at least someone who could tell me where to place the leads. Thanks

I am no wizard on coils, however I found that I needed an external 1.5 ohm on my 12 volt neg ground 1.5 ohm coil or it got very hot if the key was left on when engine was off. I used a bypass type starter soleniod so I have the full 12 volts when cranking and the resitance added when the eingine...

I purchased a Bear engine analyzer, similar to a Marquette 42-175. Can anyone help me with how to hook up the Red, Blue and White leads. I have searched the forums, not luck. Thanks, David

Those are the two I have, but apparently I need the 7 7/8 inch. Thanks for the infomation.

I have an edelbrock intake on my 59ab. I have two fuel pump rods, one shorter with an umbrella affair and one that is fatter and longer and is too big for the bushing.The problem is that the shorter one is way long, may an inch. Also, what is the stroke for the pump? Is there a sprecial push rod...

I would like to buy the shifter. Would you pm me please.

I am seeking the drivers door for my 1926 roadster. I have three passenger doors. Maybe some trade? I prefer something that doesn't need a new skin. I can fix the bullet holes.

I am upgrading my front end, steering column. Drivability is a big factor but I want to keep her looking stock and want to use the original steering wheel. I have searched and searched for an adapter to use the 3/4 tapered spline in the steering wheel and mate to a 3 bolt column. Has anyone...

I have a set of door skins I ordered quite some time ago and now I find they are too large, they mearsure 19 3/4 in across the top and same at the bottom. My body openings are 19 1/2 top and 19 1/4 at the bottom just at the top of the radius. My question is it possible the skins I have are for...

Just how much space should there be from the fan to the radiator on my 59ab engine with stock fan and genertor. My radiator will probably will end up installed on top of the front cross member, making the radiator shroud higher that the cowl on the 27 t. Is this a bad thing! I see a few aroud so...

Mac, Thanks for the information, I will check your site. Dcnner

Are the 59ab fan hubs rebuildable and if so, where could I find parts? I am speaking of the bearing.

Thanks to all of you for the information.

I just came across a early overhead valve 239. Is there any demand for these engines?