Recent content by benp

I have driven truck 700 miles it done this 2 times.Someone said check value in oil pump is sticking?

It does not do all the time driven truck 700 miles done 2 times blows oil out oil canister and oil fill cap it runs out .Like you did not have oil cartilage cover on?

I have 1951 truck flat head v8 at times blows oil from oil filter breather cap .it runs out I can lose a quart in a minute .need help Can this be oil pump check value?

@G.M. Thank you so Much this is a Huge prize link. Skip also does coils and water pump, and center support bearings thanks.

How does one rebuild a 1948 Tudor drive shaft. Have a grinding noise in the center of the shaft. Speedway has a conversion kit to install a drive shaft but I am not sure this is the way to go. Any help appreciated.

I have painted my wheels just outside .The inside is primer not rusted after all these years I left alone. I was wondering where I can lug nut washers?

I have seat covers they are red Crawford stock style fiber 2 dr. From 1942 to 1948

Had same problem hard to start hot and cold found ignition condenser bad THANKS saved a lot of head aches almost brought new coil . Now having hard time putting drag link on 1948 2 dr can't put the adjustable side on outside knuckle hits wishbone have to put on steering box . Can't get tighten.

I had the same problem no start thank you for help had bad ignition condenser

Yes I got in hurry and done this it will go together fine

Did you put the disk in backwards

No I did not remove the clip . I will let you know how it goes

Can you remove engine and trans together or seperate .is there a pan that covers the clutch does that need to come off before removing engine? 1948 flathead :

1. I have a 1948 Ford super deluxe do I need to add a lead additive to the gas? 2. Where do I get it if it is needed? 3. Where can I find the outside brackets for the sun shade that goes over the windshield?