Recent content by aojo

Berts sells a 30 amp circuit breaker that mounts on top of the starter.. I had a similar issue as you are experiencing and used the breaker while I was chasing the short.. lot easier than continuing to fry fuses. once you have solved the issue you can go back to the stock fuse setup..

Im with Russ/40 as I have about 5/8" clearance between the radiator and the pump shaft. I run a 4 blade fan and there is no way on my car to remove it to replace the pump without disconnecting the radiator support rods, disconnect the upper radiator hose, and loosen the radiator mounting nuts...

yep, that is one sweat depot hack... it was at the Time Trials meet in Santa Margarita this past weekend.. lots of very nice cars and overall great fun..

Carolina... good question.. since my car is immobile on jack stands, I needed to remove the front motor mount and lift the motor to replace the FAM donuts... this seemed the easiest way, if you have a running car I don't have any experience with the replacement.

thanks for the photo Mitch… that is a stunning engine compartment. The detailing is incredible. Is that one of your finished projects?

great stuff mrtexas. thanks for posting. my 42 backing plates, wheel cylinders, and lines seem to fit with no issues. the line fittings run through the frame forward of the shocks. System is disassembled for rebuilding otherwise Id take a photo..

Freak these guys all out M and install a Mallory dual point distributor, gut it and add a Pertronics Ignitor kit. More than enough spark for what ever engine/ engine mods you might have. And based on my experience, really reliable…(raced a Sunbeam Tiger, early Corvette, and will install on...

what ducemac said x2. Schnider puts out a great product and can do custom grinds. They have been around forever…so there is a reason they are…

I picked up a set of '34 17" wheels and took them to Discount Tire and asked them to spin them for me to see if they were out of round or useable. They did so and said when I am ready for tires the wheels are good enough that they can balance them when the tire is mounted. Didnt ask what was...

Why would he employ any since he is in Canada.? Or am I reading this incorrectly.

Great photos. I love the hill climb events.

exactly what every shop needs. this was a great idea.. thanks..

what Purdy said x2 I am in the process of locating a 39 ****** and spoke with Cling at the recent Big 3 Show in San Diego. The product look to be very well made and it works.

Two years ago I started to build a 63 Corvette motor for a project that never happened. I sprayed the bare block with Gibbs and id have checked the condition of the block every couple of weeks since and there is no sign of rust. This product is amazing. Check them out. I think there site...

When I purchased my 30 roadster a few months back it had been converted to hydraulic brakes and a start to a 12 volt system. I intend to keep the body original but will keep the brakes and finish the 12 volt conversion. I for one appreciate the advise and wisdom of those posters with...