Transmission flush

B

Birchwood

Member
I have a 30 tudor that has been setting for a good while and the transmission is extremely tight, Clutch is stiff. Is there a recommended way to flush the transmission to loosen it up.
Thanks
 
I'd just drain the ****** and add new 600w oil. Clutch is separate from the ****** and therefore anything you do to the ****** really won't affect the clutch (assuming it is a working ******). You might take up the floor board and remove inspection plate and have a look at throw-out bearing and springs. Lube the shaft the throw-out bearing slides on as needed.
 
Hello,you may also want to check the play in clutch and brake pedals and also the clutch linkage usually a lot of wear in them causing the clutch not to release completely.Some models also have grease fittings on bell housing for the clutch shaft that operates the throw out bearing.
 
Drain and add automatic transmission fluid turn by hand with rearend off the ground drain and add 600w or Mikes Afordable 1500w or heavy gear oil
 
I do pretty much as Big Hammer said but a Run the transmission with the wheels off the ground (ATF in there). I run it for a minute or so, then drain and refill so long as what comes out looks sorta OK. With no load on the gears, ATF gives plenty of lubrication and is light enough to get the goo moving.
 
There's a grease fitting on clutch bearing hub , grease there could be dried up making clutch action stiff
 
You must log in or register to reply here.
Back
Top