magneto points for anlz cnversion to ford

F

Fordestes

Well-known member
I have searched the archives for the part number for the magneto points part numbers to convert an LZ to ford to a dual coil , what is the number for the points , the last ones I bought were from air spruce I remember they offered two types one set with a spring and one without the spring
can someone tell me what the correct part numbers are and do I need the ones with the spring or without, It's been too long ago thanks .
fordestes
 
There are a couple different part numbers:

orginal article # 10-52344W and newer number is : 10-357174

available here

http://www.chiefaircraft.com/bdx-10-357174.html

Harmon Collins uses the same points as well.... I do have a couple pairs in stock if ya cant get them. $125 per set.....(1 pair )

I also have the orginal Car Craft articles with complete direction for making the LZ into this distributor... Car Craft April, May and June 1954..

Available on ebay right now , pretty cheap...
http://www.ebay.com/sch/i.html?_odk...+1954.TRS0&_nkw=car+craft+april+1954&_sacat=0

Need it synced when done let me know.......
 
Thanks Jim,
I will no doubt need your services, do you know who I may get to grind the shaft and remove the perspective lobes that are called for to be removed ? your price on the points reasonable to me, which ford dist. is the best one to use to have a good curve?
I was considering maybe setting the dist. shaft/lobe assembly in my lathe and maybe using a degree wheel to grind off the un needed lobes using my DU-More tool post grinder to remove the lobes not needed. But I would rather have someone more experienced do them, anyone here on the barn have any one that can handle the grinding?
Thanks
Fordestes
 
You must log in or register to reply here.
Back
Top