Kiwi Quickchange & CA data plates

quickchange

quickchange

Well-known member
City
Nelson
State
New Zealand
Price
$1450 app
Model A Quickchange, Also have V8 version,These would have to be the best out ther , old sandcastings to retain that old look with lots of finns. We have sold hundres of these now so well proven on highway & race tracks, Can deliver to Vancover MAFCA meet early Aug 2010 ,only have room for one more in Wifes suitcase??? also have a few Canada Data firewall plates, We can airmail any of above if you wish, these would be delivered to your address via air mail. Can mail you picture & more details if you wish. antiqueford@xtra.co.nz :):):):D To those scammers don,t bother mailing me cause lii hang one on you if i catch you :mad::mad:
Cheers Derek
 
You young ones are way ahead of me on this computer stuff, its taken me years just learn how to put a picture on , Watch out now that im started. Looking forward to the Vancover meet & looks like we just might make it to Bonniville for a day after the boat trip, Get to see my quickies running again & Catch a few of the 4-e-4 guys, Some of which are shipping their vehicles to NZ for the "Rebel " A" 2011 NZ national meet April which this time is a 7 day tour around the top 1/2 of the mainland. ;):D:o
Going to be lots of fun. :D:D:D web site www.modelafordclub.co.nz for details. Derek,
 
Hi Derek, I want to sell my new A Quickchange that I bought from you and you delivered to Arco swap meet a couple of years ago. It is still new and has 5 extra sets of new Winters gears and a Hot Rod Works open driveline (installed by Hot Rod Works in Idaho). drmyers@earthlink.net
 
Hey Derek,
How about a picture of the CA data plates. I have a Canadian Phaeton 1930.
Do I need one of your data plates. I have one of your quick Change units and can verify that they are a great purchase.
 
We are currently in Calgary heading north, Then south flying out of Vancover 27th june having attended the North West Meet in Boise, Pos back in August for the salt.
Send me your e mail direct & once home can send you a picture,
drmyers, If someone request an A one i will pass them onto you. currently have one on order so once back can pass on if they go ahead, regards to both,
 
Racer and/or Quickchange,

If you don't mind could you help me with the setup of a '48 era banjo quickchang? Quickchang or Derek, I bought it from you in January of 2011 and am just now getting around to setting it up. I had to bore out the inside of the pinion race landing to allow for the pinion gear to slip past. I'm trying to install the pionion race but even after freezing the race the bore is .008" to small. I'm afraid to push the race with that much undersize, what do you guys think? I was thinking about honing the bore to get .004" to .005" more relief. Also how do you recommend checking for pinion to ring gear clearance? Any and all help would be accepted. 55 years ago when I knew everything this wan't a problem but the older I get the dumber I get.

Thanks for any help,

Jim
 
You must log in or register to reply here.
Back
Top