Identify these carbs

[Brian in Wheeling]

O.K. Please help and identify these carbs for me. I will then move over to the swap section, if there is any interest.
Thanks Fordbarners!
Brian

 

[mantta]

The top two are tillotsen. The bottom one, if it is aluminum is tillotesn also.

 

[TinCup]

Top left Tillotson
Top right Tillotson Model XF sold by Ford
Bottom Simmons Zenith look alike but with improvements including accelerator pump.

 

[Ron in Quincy]

The top two are the common Tillotson replacement after market.

The bottom one is the first Tillotson after market made , it is called the F1B.

 

[jm29henry]

Tillies

 

[Bob C]

I don't think the bottom one is a Tillotson.

Bob

 

[Flathead]

Bottom one is a Simmons as previously stated. Looks similar to the F1B but is a Simmons. The drain plug on fuel bowl is good way to tell.

 

[TinCup]

F1B is very different than the Simmons. The F1B is pot metal and the Simmons is cast.

 

[Flathead]

The Simmons was made in pot metal and also cast iron, I have examples of both.

 

[Richard Lorenz]

The bottom carburetor is definitely the pot-metal Simmons. I also own a cast-iron Simmons, and a cast-iron Simmons that was made for a stationary use (GAV plugged up and a place for a remote throttle control).

 

[jhowes]

The bottom one is a Tilly F1B. It says Tillotson right on the fuel bowl. Jack

 

[Tom Wesenberg]

The bottom one is a Tilly F1B. It says Tillotson right on the fuel bowl. Jack

It does in Bob C's first picture, but not his second picture nor the bottom picture in #1.

 

[Ron in Quincy]

I was in error when I said the bottom carb was a F1B, it is a pot metal Simmons.

Ron

 

[Joop]

This may help!
Potmetal Simmons

..