Help needed to identify Bell Housing

harvest

harvest

Well-known member
can anyone tell me what this bellhousing exactly is from? i see marked inside T9-1&1/2. thank you for any help.
 

Attachments

  • IMG_6048.jpeg
    IMG_6048.jpeg
    88.3 KB · Views: 162
  • IMG_6049.jpeg
    IMG_6049.jpeg
    96.9 KB · Views: 154
  • IMG_6050.jpeg
    IMG_6050.jpeg
    146.1 KB · Views: 154
Certainly different. Look how high the bores for the throwout fork shaft are compared to what we usually see.
 
I don't think that is a Ford. They used the same or similar transmissions
in Studebaker, Dodge, Mack and who knows what other trucks.
 
Yup, #3 commercial bell, the smallest of the round ones. Semi's are #2 & #1. 00 for big generators.
 
Its not a Ford its missing the clearance for the starter cover on the oil pan. Also there's some missing bolt holes as well as the dowl pin alignment holes. And the throw out bearing shaft pivot points are not in the same location as the Ford Flathead Hogs Head.
Ronnieroadster
 
The Borg-Warner T9 transmission was used in lots more applications than just Ford trucks. I have seen reference to them in many other old trucks, in various tractors, and in industrial engine applications. That clutch housing looks to have an SAE bolt pattern ring on one side an industrial or tractor clutch setup, and a T9 bolt pattern on the other side. Not a Ford part at all.
 
You must log in or register to reply here.
Back
Top