Engine hand crank. Question

fredski

fredski

Senior Member
It came with the car which I purchased in 1970.

Why the other end not fit my wheel lugs ??? The tire wrench
End is smaller.
Fredski
 
fredski said:
It came with the car which I purchased in 1970.

Why the other end not fit my wheel lugs ??? The tire wrench
End is smaller.
Fredski
Click to expand...


:confused: Jeez, ...this one could be all over the place. Do you have the correct size lug nuts? Can you post a picture of the crank along with a measurement of the inside of the lug nut area of the crank so we can help you?
 
BRENT in 10-uh-C said:
:confused: Jeez, ...this one could be all over the place. Do you have the correct size lug nuts? Can you post a picture of the crank along with a measurement of the inside of the lug nut area of the crank so we can help you?
Click to expand...

Measured lug to bend5/12 inches next bend 7/12 .
The last length is 7 inches that is the end fit to crank shaft.
Wheel lugs ordered from snyders for 1930 Ford.
Have not learned to take pics.

Fredski
 
I just went out to the garage and 13/16ths is the size of lug nuts,
5 degrees outside I keep the garage heated just above freezing
When not working in there.

Fred
 
Same as Bob, I wonder if you don't have the hard to find early hand crank? If you do, you are lucky because they are much more rare than the common later crank.
 
Tom Wesenberg said:
Same as Bob, I wonder if you don't have the hard to find early hand crank? If you do, you are lucky because they are much more rare than the common later crank.
Click to expand...

May be rare also have a jack that has auto specialties engraved
On the handle . Both found under front seat and some old
Wrenches that are short and ugly.

Fredski
 
You must log in or register to reply here.
Back
Top