Distributor Shaft Sleeve

[DBSHELTON]

I need to re-install the Shaft Sleeves on a couple of Distributors I took apart and rebuilt. Would it be OK if I used 1/8" dia Roll Pins instead of 1/8" solid pins?

 

[chrs1961815]

Yes it is fine as long as it is thr right length and holds it tight.

 

[dbaldwi3]

Agreed

 

[ryanheacox]

Sounds good to me. I believe the new sleeves you would get from the vendors come with a roll pin instead of solid as well.

 

[DBSHELTON]

I just put 2 together and everything is tight. Used the same roll pins as small block and big block Fords use.