Clutch Release Shaft Position Help Please

3

31 coupe

Member
Hi all, I'm after your help again please.
I'm looking for the vertical distance between the input shaft centerline and the clutch release shaft centerline please. I'm building a custom bellhousing and want to get the TO fork at the correct height.
Thanks in advance, GB.

 
Can anyone help please?
If you have a >1948 gearbox in the shop an accurate tape measure dimension is all I'm after, C/L to C/L.
Thanks, GB.
 
3 1/4"... and I took a bit of care, this is real close- if anything, you could add 1/64" to this
Karl
 
Thank you very much Karl,
That is exactly what I needed. I'm planning a shopping trip to the US later in the year and will get a new fork from Mac's but I want to get the bellhousing underway now.
Best regards, GB.
 
You must log in or register to reply here.
Back
Top