Does someone have a copy of the instructions for installing the Brake Pedal Return Spring? If so, could they email me a copy? I removed the unit when replacing some internal parts in the bell housing, and am now ready to reintall the brake pedal return spring. Unfortunatly, I have mislaid my instructions from when I initially installed it.
Brake Pedal Return Spring
- Thread starter A-Man
- Start date
Charles Reese
Well-known member
Ron in Quincy
Well-known member
TinCup,
Standard equipment on 28's with multidisc clutch.
Ron
Standard equipment on 28's with multidisc clutch.
Ron
George Iowa
Senior Member
Reese, I am guessing that is something you made? I like it. What did you make it out of?
Charles Reese
Well-known member
as Mr. Rude said, clutch spring is an early original. the brake spring is an accessory (will remove for judging, but was in a box of stuff someone gave me so im trying it) .. brattons #3250
Joop
Well-known member
RTC1930
Senior Member
Are you using the 31 return springs or the earlier curved plate. I am running the earlier plates on mine and also cannot get the pedal to reset all the way. It snaps up fine as you describe when I let go of the pedal quickly. The issue is more when I let off it slowly or just had my foot lightly on the brakes it can't overcome the brake light switch and leaves my brake lights on. I added the brattons spring from the pic and it helped but I believe I have it installed on the other side of the actuator rod closer to trans. I will switch to what charles showed in the pic above since I don't get much spring force how I have it.
Bob NJ