57 y block

[Randall]

Anyone have a picture of puller for crankshaft balancer? The pulleys are riveted on and a standard puller no work
Thanks

 

[paul2748]

TBird or sedan. They are different.

 

[Randall]

t bird

 

[cos]

Make one. short chunk of flat bar (that will fit into slots of damper) bore and tap a hole in center for pressure screw. I used a pressure screw from a heavy duty steering wheel puller. Use a short bolt in crankshaft to center pressure screw if screw doesn't have a wide enough base to keep it out threads CS.

 

[miker98038]

Like cos said. But it needs to be stout. Here’s the one Classic sells.

https://www.classictbird.com/Tool-Damper-Pulley-Removal/productinfo/TL7/

 

[Randall]

thanks to everyone!

 

[RKS.PA]

Like cos said. But it needs to be stout. Here’s the one Classic sells.

https://www.classictbird.com/Tool-Damper-Pulley-Removal/productinfo/TL7/

I bought that one that Mike posted the link to above and that's my rating of the tool. It worked flawlessly and I'd not pulled a damper/pulley from a Y Block before, so for me it was a good value and tool investment!!

Best of luck.

Dick.

 

[dmsfrr]

Here's another example of the same T-bird damper puller. I've used it twice and loaned it out a time or two. I bought it back in '12 at a slightly lower price. It works great and I don't regret the 'pricey at the time' purchase like I thought I might.

 

[RKS.PA]

Currious Randall. Are you just rebuilding your damper, or are you replacing the front crant seal and timing chain while you're at it?