2.5" Flat Firewall Section

[Stinch]

City

Trumbull

State

CT

I'd like a good usable flat piece of original Henry steel to repair a 2.5" round heater hole in my 30 cowl. Sure, I could use any piece of steel but I'd really like original steel if possible. No need to cut it out of your car or good cowl but perhaps a scrap firewall could serve as a donor.

Rich Stinchcomb (richATstinch.com)

 

[midgetracer]

I'd like a good usable flat piece of original Henry steel to repair a 2.5" round heater hole in my 30 cowl. Sure, I could use any piece of steel but I'd really like original steel if possible. No need to cut it out of your car or good cowl but perhaps a scrap firewall could serve as a donor.

Rich Stinchcomb (richATstinch.com)

Hi Rich,
I have a couple of scrap 30 firewalls, but unfortunately they have the same area cut out. If you just want firewall steel for parching, you can have a chunk of one of these for cost of shipping.
Rod Reetz Bismarck, ND

 

[Stinch]

Hi Rod, PM sent.

Thanks
Rich

 

[Jim/GA]

I'd like a good usable flat piece of original Henry steel to repair a 2.5" round heater hole in my 30 cowl. Sure, I could use any piece of steel but I'd really like original steel if possible. No need to cut it out of your car or good cowl but perhaps a scrap firewall could serve as a donor.

Rich Stinchcomb (richATstinch.com)

Any source for a patch that is shaped properly to attach to the firewall with the 2 screws that were used to hold the little heater door/duct piece?

It would not be as slick as welding in a slug of the correct size and then grinding it all down, but faster.

 

[CHOPPSEDANS]

i have what tour looking for in firewall im in waterbury $20 2035923770