1956 lincoln premiere

Can anyone help me out with info on a starter motor replacement for my 368 LYB

Will a 292 /312 y block starter fit ?

I see your plight ... :(

EDIT -

Do you by any chance have the old starter out? If so, do you see any ID NOS on the case?
 
Last edited:
474223

Hemmings Add - Post 41. Luscious Lincoln - 1956 Lincoln Model 76B
 
I do have it out it looks identical to a Yblock one but I can’t find any ID number

That's OK ...

From what I can decipher in the old MPC(S), they are not the same. But NDP gives a listing using either ENGINEERING ID NO. -

STARTER, REBUILT, 12 VOLT, 5.75 INCH SHAFT, 3 MOUNTING EARS, LESS BENDIX

Manufacturer Reference #'s: 93501, FAR-11002-A, B6A-11002-A, FAR-11002-B, C3NF-11002-E, PB6M-11002-A

Both used the same starter drive.

Maybe give them a call for clarification. I hate to give you incorrect info.

https://www.npdlink.com/product/starter-rebuilt-12-volt-575-inch-shaft-3/159929

I never worked on one as they were considered rich man's cars ... :D
 

Attachments

  • STARTER MOTOR - 1956-59 FORD.jpg
    STARTER MOTOR - 1956-59 FORD.jpg
    20.8 KB · Views: 9
  • STARTER MOTOR - 1956-58 LINC.jpg
    STARTER MOTOR - 1956-58 LINC.jpg
    20 KB · Views: 5
You are more than welcome. Wish I could have given you a more definitive answer.

If and when you find the answer, can you post it to this thread? It is a missing factoid that will haunt me until I find out ... :(
 
474770

In Post No 4, I showed you pictures of my 1956 Lincoln Premiere 2 door hardtop which I reluctantly had to sell. The good news is that this is the same car now, looking like a million dollars. The new owner has done me proud.
 
mercman from oz it's a same car
 

Attachments

  • IMG_20210828_170827.jpg
    IMG_20210828_170827.jpg
    35 KB · Views: 14
  • IMG_20210828_170846.jpg
    IMG_20210828_170846.jpg
    31.2 KB · Views: 14
i need to moving my car but i don't have no more the return in my automatic transmission, but i would like to try adjusting the rear band, my question is: is there the hole to access on the floor pan to adjusting it ?i saw on my manual shop for 1958 is there but 1956 i don't find
it, does anyone knows about for that ?
 
... i would like to try adjusting the rear band, my question is: is there the hole to access on the floor pan to adjusting it ?i saw on my manual shop for 1958 is there but 1956 i don't find
it, does anyone knows about for that ?

Unless you find the answer on a LINC FORUM, you will probably have to get what is shown below (CD) -
 

Attachments

  • AT WSM - 1951-1958 MERC-LINC.jpg
    AT WSM - 1951-1958 MERC-LINC.jpg
    35.6 KB · Views: 5
Back
Top