Search results

Yes, it runs but no power on grades and engine shutters at above about 20 mph. I was gonna set the gap to .025 inch. I know there may be other problems but thought to start here!!!!!

I have Nu rex electronic ignition and the cam has to be where it is located to trip the modul. I could shorten the extension for the rotor, but, if I lower it down I'll still have the 1/8 inch horizontal gap. The rotor is definitely seated and the distributor body is seated. No obvious evidence...

I decided to check the rotor to distributor body pins gap and found the horizontal gap to be about 1/8 inch and the vertical to be about 3/16 inch. Help, any ideas on fixing this issue? Pictures attached.

I decided to check the roter to distributor body pins gap and found the horizontal gap at about 1/8 inch and the vertical gap to be about 3/16 inch. Help, any ideas on resolving this issue. Pictures attached.

Hello Fellas and Fillies, I have disassembled my shocks cleaned them up as best I could with kerosene. They had some really oily black gunk inside but appear rebuildable to me with an untrained eye. They have a small amount of surface rust scattered about in small areas but can be...

Hi Tom, Thanks for the pictures. I never would have thought that it needed that much grease. I had searched for universal joint threads and read many of them. Some said to much grease could be forced up the speedo cable to the speedo causing a problem. Since I already have it together, I...

Sorry Tom, Had a momentary brain farcal. Jim

Hello Don, Thanks for the heads up. I should have stated that not only the inner cover showed signs of rubbing, but also the universal joint shows signs of rubbing. I guess the universal could have gone bad and someone could have rebuilt it in the past. The visual of the cover and UJ seem...

Hi, I'm getting their it's just a slow process!!!!!! I have my differential / torque tube assembly out of car and inspected the universal joint. Seems to be no rotational wear at all. My concern is the end to end along pin movement (about 1/4 inch from stop to stop...

Call "Bert's model A Parts" in Denver, Co, I recently purchased one with basic wiring harness and they worked like a charm. It's a reproduction but fits well with the harness. Good luck

Thanks everyone for the information. With this new information I will to resolve my issues and let you know of my progress. May be a while. Thanks again. Jim

I am relatively sure it is a 7-tooth because of the configuration of the housing.

Hi again Mr. Bob C., Sorry I thought you were referring to the test thread I posted yesterday. I do not see one entered at 8:02 today?

Hi Mr. Bob C., I would gladly "delete", if I could figure how to. I can get to the edit screen but can't figure out how to delete. Sorry

Hello Fellas, Newby here and have a couple of questions for all you (experts in my book). Joined last September and been hanging in the shadows reading threads on this very informative forum. Really have enjoyed reading a lot since September. I have a...

Hello Fellas, Newby here and have a couple of questions for all you (experts in my book). Joined last September and been hanging in the shadows reading threads on this very informative forum. Really have enjoyed reading a lot since September. I have a...

Hello Fellas, Newby here and have a couple of questions for all you (experts in my book). Joined last September and been hanging in the shadows reading threads on this very informative forum. Really have enjoyed reading a lot since September. I have a...

__xxxxxxxxxxx Xxxxxxx Xxxxxxx__xxxxxxxxxxx Xxxxxxxxxxxxxxxxxxxx

This is a test to try to determine what i'm doing wrong?

Thanks fellas for the kind words and welcomes, I just spent an hour and half writing a thread I wanted to post. I logged in and sent the test thread, received confirmation it went through, then began to write the question thread. Having finished I hit preview thread and it took me to a sign in...