Search results

Hello Astozombie, Do you still have the distributor for sale? I am interested, Thanks, Drew

R + L Carriers would be an option, too. http://www.rlcarriers.com/

You might need a loading dock and I wouldn't plan on getting where you're going too fast, though.

You might want to check the MAFCA suppliers list for who you are looking for: http://www.mafca.com/suppliers.html

This is from Vince Falter's FordGarage.com website: http://www.fordgarage.com/pages/tighteningsequence.htm

Hello, I am looking for either of these side mirrors for a '29 AA truck: A-17741 AA-17745 Thanks, Drew

Hi Kane, Here is a thread from the AA truck forums that show the bracket and how it was riveted to the windshield frame. You might want to check Berts to see if they have an original but the right person could probably make one, too...

Here is what I think and hope was happening with my stop light switch. The insulator was broken and missing under the rear connection on the switch from being over-tightened. This resulted in the attached copper blade being in contact with the copper blade from the front connection and the...

"OK my guess is that the problem is in the repro light harness switch or the headlight connectors in a head lamp. Especially if you are using repro sockets or connectors." Mike, When I had the stoplight switch disconnected I also tried the headlights and they worked on both low and high...

The cutout and generator were just restored by Tom Wesenberg so the cutout is good to go.

I disconnected the brake light switch and and turned off the dash light and it was still drawing 5 amps when I connected the battery. I think it must have been 15-20 amps with the brakelight switch connected, not 10 amps like I stated earlier. I disconnected the yellow wire to the starter and it...

It didn't seem like a big spark when I hooked up the negative cable, but it definitely sparked. Also, it may have been more than 10 amps, my head was stuck down by the floorboards disconnecting the battery so 10 amps was secondhand information. I'll try disconnecting the brake switch next time...

Yep, positive ground is how she was hooked up.

I had high hopes I was going to be able to get the AA started today because my mother-in-law and father-in-law were there(it was his dad's truck). We had a nice lunch and my kid's were hoping for a ride. I warned them it might not happen and now, in hindsight, I should have hooked the battery...

Gunmetal(post #2), I'm think you are referring to the AA speedo cables which are 85" long and go through the crossmembers. The cars are routed differently and are only 61-1/2" long.

Ray, I don't have a tire cage, so I don't want to deflate and reinflate my AA's tires because of the snap rings holding them on the wheels. I've heard some stories of the damage they can do. Otherwise, I would do it in a heartbeat.

I wish I had known about these before I had my AA truck tires mounted, now I'll have to wait until I get a flat or wear the current tires out.

I could use some advice (and/or pictures) on where the joint between the two ends of the roof welt should be placed. Do they join at the back center of the cab, one of the corners, etc.? If I had to guess from this picture, http://abarnyard.com/temp/82-a/82a-31.jpg, Marco put his in the...

I am also getting ready to complete my closed cab AA roof and am wondering what type of welt you've all used. I had ordered fender welt from Snyders for this, but it's a shiny vinyl that has no pattern in it. It's difficult to tell what you are getting from the pictures and descriptions on the...

Pluck, My original bed strips all appear to be "cupped". Unfortunately the repros are a far cry from the originals. Drew