Search results

I used a Ford proportioning valve I got off ebay for about $35 and and a adjustable push rod from ebay for around $14 to get it dialed in.

I have done this for a 56 T-bird and my 57 Ranchero both with manual disc and rear drums, I got mine from Autozone its for a 76 Maverick with manual front discs and rear drums part# NM1680 its new not a rebuilt for $62 been on my Ranchero for 12 years no problems.

Still looking for rotors, this is what I need without the hub just the rotor.

Looking for one or a pair of 65-67 mustang- cougar OEM style front rotors that take the bolt on hub, must be usable as is or be able to be turned with a minimum of .780

I was there with my 57 Ranchero and say a car with # 2964, a lot of 46-48 fords from Canada at our Hotel. We were 1.6 miles from the fairgrounds and it took 1-1/2 hrs. to get to the entrance gate.

Found one

Anybody parting out a 1958 Edsel, I'm looking for a front sway bar doesn't matter what model just as long as it's a 58.

Anybody out there that owns any model 1958 Edsel that could measure the front sway bar and tell me what the diameter is.

Have you looked at Modern Driveline they have a lot of good info and adapters for the y-block for the 5 speed.

Does anybody know if somebody makes a dist. cap clamp on style with male connections hei style instead of the push in female style that would fit an OEM 65 small block ford distributor.

Is anybody running a Mallory unilite distributor with a y-block and overdrive ******. I can't seem to get a straight answer from there tech support whether or not it will damage the module when you shift out of o.d. My understanding is when you kick down the switch under the gas pedal to shift...

This might be a stupid question but why aren't you using mustang spindles it's not like there's a shortage?

The 59 latches are a pretty popular swap in place of the 57-58 style, I put one on my 57 Ranchero about 10 years ago you can shut the hood with one finger instead of slamming it shut with the 57 style.

Make sure the lever is in the right position and then drill the hole out slightly bigger to accept a larger roll pin, just a thought.

Re: Y-block ‘B’ intake manifold question That will make a nice combination my buddy did it to his 56 F-100 with a 292, he is using a 500 cfm Edelbrock carb. runs great.

When I was building my 57 ranchero I searched everywhere for a new sending unit with no luck, I tried using a 57 reproduction unit for a car which didn't work, tried bending the float rod to match the ranchero/wagon didn't work. Sent my original one out to have it modified to work that didn't...

btt

Looking for a really nice 1935 ford pickup grill, I know a 36 will fit but really need a 35. Must be in really nice shape not all rotted and bent up, willing to pay a (fair) price and shipping for the right one.

Original wheel size is 16x4.5 with a 5.5 bolt pattern, tire size was 6.00-16 and 6.50-16

Looks like you got it figured out, I have the same set of mounts in my 57 Ranchero with a 351W with no modifications, Cleveland must be a little different.