Search results

Looking for a 7HA-6264-B camshaft hub for an H series six cylinder. rdove2989@gmail.com

Need 1941-48 sedan passenger's side outside stainless windshield trim. No dents or bends. rdove2989@gmail.com

Looking for recommendations for a good indoor car cover.

Will a V-8 brake pedal retracting spring work in place of one for a 226H six cylinder engine? The "green bible" gives part # 6HA-2456 for the "H" engine. If not can someone tell me the length of the 6 cylinder spring. Thanks

Thanks...maybe these pictures will help

I ordered 1/4" thick glass for the doors and quarter windows. Is it possible that I need 3/16" thick glass? Did Ford use 3/16" glass? Screw holes for the vent window panel seem to be off about a 1/16 of an inch. Also, I had a hard time getting the bottom track on the door and quarter glasses...

I did buy my glass from Sanders and it was too tall. I did the same as you and took it to a local glass shop and they trimmed it to the right size. I can adjust mine to roll up and down fine until I put the vent glass assembly in and then it binds the glass so that it won't move.

I am using a Vintique kit. I tried adjusting the track but doesn't help much. I had a hard time getting the vent window panels in at the bottom and the screw holes didn't line up well. I'm using the original panels and doors on the car. Very puzzling.

Hi, I installed new door glasses and new anti-rattle strips on my 1948 two door. When I install the panel with the vent glass and new anti-rattle strips it seems to pinch the window and makes it very hard to roll up and down. I installed the strips even with the top of the panels and door. I...

I have a 1948 two door sedan. The scuff plates that hold the carpet and mat down were missing so I ordered new ones. Does the enclosed end go toward the front or the back of the interior? Thanks in advance

That's a great picture. Very helpful. Did you have those done locally?

Thanks for the info! These are cloth from what I can find out.

I have a 1948 2 door sedan with grey interior. Since Cartouche no longer reupholsters assist straps or any interior work. does any one know where I can get the correct material to get them done locally. I contracted them to try and purchase just the material that I needed. They told me...

Wanted: 1946-48 assist strap screws and washers. Need 2 of each in excellent condition.

Hi, Can anyone tell me if the interior sun visors for a 1948 super deluxe were originally cloth or vinyl and is anyone reupholstering the assist straps. Cartouche no longer does that. Thanks

Thanks for the info Bruce Mo. About 3/8" from the top edge of the door makes sense because the upper door seal on the body is about 3/8" wide. I don't have the clips like your '46 does because there is no trim around the windows on my car so I probably need to move the back seal back...

The picture is of the upper back edge of the driver's door.

Hi, Two questions: first is about the back edge of door weatherstrip - How far up the back of the door does it go? My other question is about the bottom window channel - Does the tab on the end of the channel go toward the front or the back of the door? I've attached a couple of pictures to...

I am replacing the 1/4 windows on my 48 tudor sedan. I am replacing the interior so I have removed the trim panels and the panels that the regulators bolt to. Should I have the regulator in the down or up position when attaching the glass to the regulator? I'm assuming down so that the glass...

Thank you all for the excellent info. The 1941-48 Book has great info in it. Maybe this should be added to it. Thanks again.