Search results

  1. N

    Going to Hershey & need space to park or camp?

    If one is looking for a place close to the Hershey fields to camp and park, I know of a great spot. It is the Hershey-Derry Historical Society right by the shopping mall just east of the Hershey fields. They have limited spots for a camper or trailer or just vehicle parking. They charge very...
  2. N

    My '53 sticking in 3rd gear!

    My '53 Ford V8 with standard transmission locks it self in third gear! I have to crawl under with a wrench to release. It still does it again. I did change the input shaft prior to this problem. Does that have something to do with it?
  3. N

    I Can't Stop My Clutch Chatter On My '53!

    I have a 1953 Ford V8 stick shift with bad clutch chatter! So far I have done the following: new clutch disc, new pressure plate (3rd),new throughout bearing (3rd), new front engine mounts, new transmission mount, new equalizer rod and bushing, new universal joints (3rd), resurfaced...
  4. N

    Where can I get new lifters for my 337 Lincoln flathead?

    I need 8 new hydraulic lifters for my 1951 Lincoln 337c.i.d. flathead. I'm replacing all on one side of the block as some are sticking. Any ideas?
  5. N

    Looking for bell housing pan for 52-53 Ford or Merc

    I need to find the pan that goes on the bottom of the bell housing on my 1953 Ford Victoria V8 standard. The 52-53 Mercury should be the same, I think.:)
  6. N

    Needed-lower bell housing pan for '53 car

    I'm in need of the pan that goes under the bell housing of my 1953 Ford Victoria V8. I think the 52-53 Mercury is the same. The part number is 6409, I think. :)
  7. N

    Clutch release rod needed # AB-7521 new or used

    I am of need of a clutch release rod # AB-7521 for my 1953 Ford Crestline. A used rod would be OK. I've tried most sources, I think.
  8. N

    AB-7521 Clutch release rod needed new or used

    123
  9. N

    Clutch release rod 7521 needed for '52-53

    I am in need of a n.o.s. clutch release rod number 7521 for my 1953 Ford. I need to replace a (made up one) poor quality rod. Who might stock one?:)
  10. N

    Wobbly drive shaft problem!

    The drive shaft on my 1953 Ford V8 standard shift appears to not be straight. I can see it wobble jacked up idling in first gear. On the road I feel a strong vibration. So far, I have thrown the drive shaft off TWICE! I'm on my third set of u joints. Should I try to find a new shaft? :(
  11. N

    Wanted: 1953 car grill bar

    I am of need of the passengers side grill bar number 8150. I need it to be a nearly perfect n.o.s. to match my other side which I found already. :)
  12. N

    Is there a good chemical to quiet lifter in my '51 Lincoln flathead

    I'm still trying to solve my problem with a noisy lifter in my '51 Lincoln flathead. Is there a good reliable chemical I can add? The noise appears only after the engine runs and warms. When cold, it's quiet and runs great. I have run lots of Mystery Oil in the crankcase, but no help. I'm now...
  13. N

    Noisy fuel pump push rod-1951 lincoln

    :confused:THE FUEL PUMP PUSH ROD ON MY 1951 FLATHEAD LINCOLN GETS NOISY AS THE ENGINE WARMS UP. IT IS A HOLLOW ROD THAT ALLOWS THE OIL TO LUBE THE PUMP LEVER. IT HAS BEEN CLEANED AND THE PUMP WAS SWAPPED, BUT STILL THE SAME PROBLEM. THE FUEL PUMP IS A DOUBLE ACTION TYPE. ANY IDEAS??
Back
Top