Search results

How to use vintage apco mossberg dial seems to go 24 inch lbs. If torquing head to 55 ft lbs.

Have remove lock and there is a number on the shaft No. A1102. Don't know if this is key number? If so can I get a new key?

How far in does the needle valve go is it meant to close off the bottom holes in the rotor wing?

Oil Filler tube came out while driving found it on road when returning. I didn't lose much oil although plenty splashed around engine and firewall. Have put it back in hope it doesn't happen again. Any suggestions how to stop this?

Not sure how to fix this left hand light very close to radiator right hand light further away to the right?

Repo set the holes/slots that have bolts to guard are vertical the guard holes/slots are horizontal. Does anyone know if the splash shield holes/slots are meant to be vertical or horizontal?

This is on an AA Truck it appears that to install these inside I have to cut out a piece where the top hinge is located in order to fit them home. Has anyone had to do this?

Hello, Have piping from Snyder's I think it runs up the post have taken off inner piece that has 3 screws to hold it but cant work out how to get this installed this is RH drive but guess posts are the same for LH drive. Any help or pics. Thanks

1930 4 door Firewall has a couple of pipe retaining clips? how does the piping go from manifold to these then through firewall? I have new black flexible hose and pipes at each end from Synders.

Need picture of how needle fits in orginal ammeter.