Search results

Need late 31 throttle assembly with rivet not worn out. John Phone 517 522 4492. Thanks

Has any one tried to replace or repair the rivet and the steel stamping where the rivet goes in the Sept. 1930-end of production throttle control assembly.If you have how. Thanks John

What is the best way to adjust hand throttle. Mine goes halfway down before speed increases. Thanks John

What is a quick fix for a drip where the hose meets the pipe . The clamps are tightened all the way down. Thanks John

Installing new engine in car .The front of engine is off center 3/16 of a inch. What is best way to correct this problem Thanks John

My readings on FW to FW housing are 12 o'clock- 0, 3 o"clock 91 thousand, 6 o"clock 0, 9 O"clock 97 thouother than sand. Is this variation ok or what can I do other than replace housing. Thanks John

What is the proper route or direction of the wire to go around the four bolts . The holes in the bolts are not always in the right place. I have the safety wire pliers. Thanks John

A lot of guys balance the flywheel first and then balance the flywheel and pressure plate together. What good does it do to balance flywheel alone when you have to rebalance it when you attach pressure plate and redrill flywheel.Thanks John

Which way is best to install engine? With accelerator assembly on block or without. Installing with it on could scratch firewall , with it off could loose shims when bolts are removed. Thanks John

I am trying to adjust my v8 pressure plate fingers the problem is I get a different reading on the same finger when I change the location of the flat piece of metal across the surface of the back side of the pressure plate and measure down to each finger. Help. Thanks John

How many of you guys are using shoulder bolts on your V8 pressure plate . If you are where are you getting them.Thanks John

Has anyone heard of putting a "spring steel" between the clutch disc and lining . My clutch man says this will help clutch chatter. Thanks John

Trouble reading instruction from Antique Engine rebuilding to make a engine crate for shipping engine. Help Please Thanks John

Does the starter shaft turn when the engine is running? I hear a knock in the stater shaft with a stethoscope when the engine is running. Thanks John

Should Snyders 5.5:1 Model A head have more Compression then a regular head. Mine is 60 60 60 55 Thanks John

What is the fix for blow by. Could blow by cause excessive oil leaks Thanks John

How do I fix clutch chatter starting up in first gear only. I have a cut down flywheel, V8 pressure plate, and a clutch disc three years ago. The problem started then. Where do I start. Thanks John

How to check rear axle housing bolt holes to see if they have a taper with out messing them up. John

If I pay my bills in Canada with credit card will my exchange rate be good. John

What is the temperature of your brake drums after a long drive and what temperature should they be . Mine run around 127 degrees. John