Search results

Did a search and I couldnt find any answers, so Ill have to ask here on the board. I changed the timing chain on my 59 292. I installed the gear, fuel pump eccentric, spacer, washer and cam gear screw. And the fuel pump eccentric is still loose. There is a .045 gap with screw bottomed out on...

Can anyone tell me if the 39 Mercury steering wheel the same as a 40 deluxe. If not, how much difference is there? They look awful close to the same.... Thanks

Looking for a 1939 Mercury speedometer to fill the hole in a Mercury dashboard. Thanks!

Just wondering which transmissions I can use behind the Flathead in my 53 F100 panel. Will the later light duty standard 3 speed from the Yblocks work? I'm almost positive it was just a light duty in there from factory. Don't know for sure though, because the engine is still there, but no...

I'd just like to get the engine running on my '59 galaxie. The engine is a 292 with OD 3speed. Someone swapped in a straight 3speed and the wiring is kind of a mess. Can anyone tell me what this resistor looking thing is next my coil. It is wired to the distributor side of the coil. Is it...

What are you folks out there running for fluid in your Merc-o-matics? I have a 52 Mercury with a Merc-o Matic that hasnt ran for at least 25 yrs. would like to start the car and just drive around a little, be able to drive on the trailer, etc... Thanks

I have a 59 Convertible with a bad frame and have found a 57-8 Ranchero frame for sale. Can anyone tell me if they will interchange. Or if they are a close match, what changes have to be made? Thanks in advance!!

How about some posts of pictures of some of the license plate guards of the 50's Fords.I'm having a hard time finding any on the interwebs. I'm personally interested in 1957, but all years would be interesting.

I have a couple of 94's with stuck and corroded throttle blades. I havent had them all the way apart yet. But I was thinking if they are corroded and pitted, is there a way to fix the pitting with and epoxy or other material. Of course being careful not to plug any holes and also careful honing...

As the header states, I want to take the Merc-o-matic out and replace with a 3spd OD.... Same question with the pedals??? Thanks in advance

I am looking for the upper door and rear quarter panel trim for a 55 Mercury. The trim that goes right below the glass. Doesnt have to be perfect. Thanks

I have a 59 Ford 2dr Hdtp with a bad frame but savable body. Can I use the frame from one of the Edsel 2dr body styles? If so which one? I have heard that one is smaller than the other. Thanks

Hi all, I have heard there is a place that sells the full length reproduction rear quarters for the 59 ford. I think it is pronounced like "shots", but I dont know the correct spelling. Can anyone help me out? Thanks

Im looking for a bell housing to mate a 390 to a T-10 trans. Its the narrow bolt pattern pre-65 date codes. Could use the clutch fork and linkage, and the shifter and linkage, too. Thanks

I have a 59 Fairlane with an fe motor. I also have a big car t-10 that I'd like to run behind it. Has anyone done this? I don’t have a bell housing....what is the best one to use? Anyone who has done this---what do I have to look out for? Thanks in advance!

I have a flattie in my 52 F-5 and it seems to be a mixture of parts so I am guessing at what everything is. It has 8cm heads but what looks like a 8ba intake and 94 carb. I'm guessing someone wanted a little more power and replaced the Ford motor with the Mercury motor and kept the intake and...