Search results

Looking for an original folding jack handle. Model A-17081-B used with C model jacks.

Before going the repo route thought I would see if anyone has a good used origonal radiator shell emblem for a 1930. Thanks in adavance for any help.

What are the differences between 28-29 and 30-31 rumble lids? I see vendorsselling the same skin for both but not same complete lids.

Am ready to put the vinyl on my 31 S/W sedan. The instructions with the LB kit call for using a sealant under the edge of the material. Does anyone have any recomended products for this use? Thanks.

Two questions, need to repalce header. Do you have to cut and remove metal header panel to accomplish this? On rear valance panel there are 3 holes on each end flange. Are these holes used to bolt to fender? I have an original fender with dimple and there are no holes for this? Thanks for any help.

Have one inside door handle for my standard S/W 160A Four door sedan. Can use 3 or 4 to complete set. Thanks in advance for any help.

Looking for an original Murray 160A body tag for my 1931 S/W Sedan. Thanks in advance for any help.

Looking for a nice 30-31 passenger side four door sedan rear fender. Let me know what you have. Thanks!

Need one late 1931 front fender brace with the reinforcement at bottom mounting part. Thanks for any help.

Wanted for 1931 sedan passenger side rear engine mount and driver's side rear running board bracket in good original condition. Thanks!

I will be repacing the floor pan under the front seat of my 31 S/W sedan. What is the best way too do it. Cut out old one and tack weld from top or bottom? How much overlap from old to new? Any tips appreciated.

Looking for a pair of rear bumper extensions for a 31 S/W sedan. These are the short pieces that attach to the longer bracket and support one end of the bumper. These are longer that most at approximately 11" long. Thanks for any help.

Does anyone have measurements, photos or ways of identifying the rear bumper brackets for a S/W sedan? I am looking for some for my car and want to be sure they are the right ones. Thanks.

Does anybody has some good tips for removing the door hindge pins on my 31 S/W sedan. I've tried heat, penetrating oil and a hindge pin removal tool with no luck. Finally drilled out pins on front door as I have extra front hindges but don't want to nrisk damaging rear hinges as I have no extras.

I got a rear fender for my 31 sedan that was listed as a 30-31 fender. I t doesn't apper to be quite as tall as my old ones and where it attaches to the running board has a ridge about 2 inches from the bottom that is not as flat as my old one. Could this be a 28 -29 fender or something else...

Back in the 1970s when I bought my first Model A there was a guy by the name of Don Summers from Michigan that had a catalog of repro sportlight parts. I recently got back into the hobby and am looking for a clear domed lens for a J-1. Is there anyone dealing in these parts today? Thanks for any...

Does anyone know if the rear seat armrest from a Victoria are the same as those for a Slant Window four door? Thanks.

Looking for the following parts for my 31 S/W, Dome light, rear bumper brackets, rear valance and nice pair of front fenders. Thanks.

Need good windshield frame for a 1931 Slant Windshield Fordor. Thanks for any help. wfort39663@aol.com

Still looking for some parts for my 1931 Ford Coupe. Need a bare fram and rumble lid. Will be travelling from NM to Ohio in June and could pick up along the way.