Search results

Is it possible to remove the oil pan on a 292 in a 56 Victoria with out removing the engine from the car? Thanks Len

Any problems using edelbrock carb with 1956 distributer. Thanks

If you initially fill the OD and trans with oil will the oil move between the two so it is possible to just check the trans. The car is a 53. Thanks

Any recommendations for a shop that works on the Borg Warner electric overdrive on the west coast. It is in a 53 Victoria.

How can I determine what rear end ratio I have? Thanks

I am in need of a original 1937 gas cap. Leonard 530-401-8660 brewer_l@sbcglobal.net

Never used Bubba Chevrolet converted dist. with vac. for 8BA. 530-401-8660 brewer_l@sbcglobal.net

Can anyone tell me the No. of teeth on speedometer gear for a stock 56 ford with three speed + overdrive. Thank You

All I have been able to find is the 85-90 GL5 gear oil is this the correct oil to use. Thanks

Recently rebuilt 292 great compression, no smoke, doesn't overheat has excessive oil coming from draft tube assembly on side of block. Any suggestions as to cause. Thanks Len

On my 56 I am on my third pump from Napa. All three developed a oil leak in a short amount of time. Any other supplier that has a pump that doesn't leak? The leak is not from the mounting flange It is the shaft that that supports the actuating arm. Thanks

Anyone had any experience opening up a 51 horn to check the adj. It appears to be a closed unit. Thank you Len

Any tips for installing horn wire on A 51 FORD. There is no wire in shaft now. Thank you Len

Anyone had any experience using a 6 volt solinoid with a 12 volt system?

Is it possible to remove a V8 with a overdrive trans It is a 53. I am thinking it might be easier to install when I finish working on the engine. Thanks

Can anyone tell me the correct Speedo gear for a stock 1956 with a three speed and OD. Thanks

Anyone have any sugestions for a wrap for fuel lines to help prevent vaper lock.

`I would like to put a 289-302 into my 53 and retain its 3speed overdrive trans. Has anyone done this. Probably put a more modern front end in also. Thanks.

What is the procedure for removing the Ignition switch on a 56. Thank You

Did ford use a dropping resister for the gas guage and the water temp sender? I seem to remember hearing that ford used 6 volt guages for a period after they switched to 12 volt.