Search results

I'm getting ready to install new fuel lines on my '37 Pick up. I have a new fuel tank and it has been a few years since I removed the old lines. I would appreciate a few pictures which show the routing and location of the lines from the tank to the motor. I...

I've been looking every where to find information for the oil lines from the filter to to the port on the back of the block and from the bottom of the filter to a port at the intake. Size lines and fittings? This a 24 stud from 39 panel.

I finally got one of the old perch pins out today. All it takes is some heat, a drill, some more heat, penetrant, some more heat and a BFH!. The other might come out easier I hope.

What a treat to come to this city for other reasons and find a parking lot full of T's. The license plates were from all over and when there were mechanical problems it was fun to see that each owner came prepared with spare parts. This is a great bunch of...

Sometimes called perch pins. Previous owner changed these and they won't let me use the shock absorber link. I found a pair of NOS perch pins and I am in the process of changing them with the axle still on the frame. I have a spring spreader to keep the spring...

When I set my radiator in position the lower hose outlets are about 1 3/4 inches below the water pump outlets. Is this correct?

The original 37 has the radius on the bottom of the top tank. Tires is Dulop racing tire, 6.50 - 16

After almost 30 years a motor is back in the frame. Is it possible that i may have reversed the throw out bearing? I can't adjust the clutch to disengage the pressure plate.

I was riveting 4 replacement clips on my rims today. Thought I was all done and after the clips cooled, I pushed on one to make sure it was tight and it broke off. Now I need at least one more clip.

I'm slow....

This my project for the next few weeks- clean, paint, replace parts including installing the original cable brakes. What is the spacer for underneath the spring? After I rob a bank, tires.

Finally removed the cab from the frame today so I could remove the center brake assembly. Previous owner converted to juice brakes and I am going back with cable brakes. You can see where they welded an extra bracket to one of the arms. Can I just grind that part off...

Which of these air cleaners is the correct one for 1937 Ford pickup?

I am replacing the kingpins on my 37 and I could use some advice or tips. So far I have the new bushings installed in the spindles and I am ready to put the kingpins in but they seem very, very tight. Would it better to take the axle off and take the whole thing...

I took the steering box apart today on my 37 1/2 ton pick up. The tube which goes down the center was broken off and the wire(s) ionside cut off. I haven't found anyone who sells the tube and is the wire just for the horn? Going to a local machine shop...

After sitting for many years I am slowly putting my 37 1/2 ton back together. I have a rebuilt 24 stud from a 39 panel and the transmission and I also have the transmission that was in the 37 which has a BB serial number. The 37 trans. has a small type of wire...

After sitting for many years I am slowly putting my 37 1/2 ton back together. I have a rebuilt 24 stud from a 39 panel and the 39 transmission which might be a 3 speed. The pick up ****** is a BB and there is a type of shaft that is along side the gear shift with a lever at the top. What is this...

I am trying to rebuild the brake/clutch pedal assembly for my 37 1/2 ton pick up. I have it all apart and I have found all of the replacement parts except the pins that are pressed thru the shaft pin at each end. When I took it apart I had to drive the old ones out with a drift pin. Does anyone...