Search results

Looking for a photo of the C pillar. The shape of the pillar at the bottom where it joints the running board and rear guard. Also a good photo of the trunk when it is closed. Thanks

Just purchased rear rocker box for my sedan from EMS. It comes in 3 parts I can see the parts that make up the box section but what is the third part for. It is a flat piece with holes punched to match the running board mounting holes.Are there any instructions out there on installing these...

Does anyone do camshaft bearing Standard OD and +.010thou ID.

What supplier does 3 3/16 pistons 3 ring +30 or +60 over. All I seem to find are 4 ring pistons. Thanks

I getting ready to do the oil modification on my 59A but I am confused. Read many different threads. Attached are some articles with good information. One articles call for a 9/16 hole drilled down into the pump cavity the other use 7/16 hole which is correct. The hole you drill for the return...

Any done this themselves. In the process of converting my diff to the Hot rod works axle modification. Needing to check diff for straightness due to welding on lugs and axle bearing ends. Starting to make up the mandrels to fit in each bell bearing location. Going to use a 1.500 inch shaft what...

Need some help. In the process converting my 47 sedan to open drive shaft and need info on the radius rod bracket. Hotrod works does not do this bracket for this year. Can anyone give me a heads up on what they have done to secure the radius rods to the chassis. Some photos would nice. Thanks Howard

Has anyone done this conversion. What procedure did you use to machine the axle housing billets. I was think about removing the billets from the housing and using a lathe to machine. I think the billets are only butt welded to the housing. Anyone have any thoughts on this. I only have access to...

Needing some advice, finding it very hard to find a good drive shaft over here. The best shaft I have has the front section damaged where the roller bearing runs. Is there a repair or sleeve arrangement that is being done to the front section where the roller bearing is running. When...

Does anyone make rain gutters for these vehicles?

Need some photos of the rear trunk area. Doing major rust repair to this area. Need photos of the lower trunk lid panel. The floor area, The corner stiffeners. The cap around the lid to body area when fitted correctly. I want to make this area water tight as they seem to leak. Any photos of this...

Does anyone have any adjustment procedures to setup the trunk lid correctly. Thanks