Search results

After reading the excellent discussions about removing the original fuel tank, I have a question about a replacement. In a post dated 4-2-2016 Dennis(EV8G) included this statement: "Just to make you aware should you decide (for some reason) to replace this tank, Bob Drake reproduction tanks for...

There is an excellent post by JSeery dated 4/6/2015 concerning gauge operation. After reading this information it appears to me the the gauge operation is unaffected by a change from positive to negative ground. Is this conclusion correct?

The fuel tank outlet tube on my '37 is damaged and needs to be replaced. The retaining nut fitting has been rounded off and will not accept a wrench. Prior to my attempts to loosen the fitting, I am asking for help in understanding the connection. The tube must extend about three inches through...

Is this the correct mounting assembly? The picture shown is how I found it. The radiator tab is on top of the rubber pad. The bolt is through the rear hole on one side and the front hole on the other. The car is a '37. I am in the process of installing an 8BA and the radiator position is...

I chose to install the steady rods in the 8BA block using the existing threaded boss on the block. The configuration uses a threaded stud in the boss that protrudes about 3/4 inch from the bell housing flange. A 1 3/4nut extension was installed on the stud and tightened to provide clamping on...

I am in the process of installing an engine with an 8BA block. The steady rods need to be fitted to the block by drilling out the hole locations at the rear of the block. Attached is a picture taken by someone who has done the job. Possibly I found it on this Forum. I want to do it properly. Any...