Search results

Hello, do you have a Standard or Deluxe? Could it be you have side curtains that are mismatched?

Hello, another thing to check is the arm on the clutch shaft were adjustment is made , ,these have been knows to crack,hard to see some time have some one push down the clutch while looking at tha arm under neath the car

Hello,bought the valve upgrade from Snyders and just fitted it to a Burtz block, have the single lock tappits as the have a larger base .still working on it so can’t say if better performance.

Hello, that Marvel Mystery Oil been around a long time, remember red cans of it in my great grandfather’s garage,also had an oiling system that attached to intake manifold, consisting of steel lines and a glass jar.And it smelled good too !

I live near Erie ,Pa … let that place be avoided until grass grows in its streets…. 1853 Horace Greeley , about 2 hours away ,but any how got back working on Burtz , installed cam and valve train .preset lifters to 2.5000 as recommended before installing.

I live near Erie ,Pa … let that place be avoided until grass grows in its streets…. 1853 Horace Greeley , about 2 hours away ,but any how got back working on Burtz , installed cam and valve train .

Hello again, there is a Model A around here that someone built a boat tail speedster out of wood, I think it only has the original steel cowl the rest is varnished wood with brass screws holding it together quite impressive,sorry I don’t have a picture.

Hello, what model is your 51 Plymouth? I had a 52 Plymouth Cranbrook ,used it as a second car in summer time.My wife even liked it!!

Uh oh, I see the censorship is back, I guess I should have used the word push rather than **** !

Hello, on my experience on British cars , the electric fuel pump like to push fuel rather than **** it ,pumps are usually located close to the fuel tank. On a Model A perhaps on the firewall?

Hello, I used the reamer from Snyders and it worked good, main thing is that both bushings are on the same center line the reamer is over a foot long to accomplish this . Honing would give a better finish but personally I like to do things myself.

Thank you, I appreciate your effort for this .

Hello , Dodge tryed to pm didn’t go through, please explain more. Thank you.

Have them in ! Thanks everyone for your help!

Hello again, frame welt will only extend to end of splash aprons , the rear most blocks have just the rubber pads in between wood and frame, also usallly blocke will have a slight recess where pad fits.

Hello, the rubber pads will fit on the bottom,on top of the splash apron or between block and frame welt . The rubber pads are also used to shim the body to adjust door openings.The is on Ford Barn a good post on how this is done.

Thanks for the replys one more thing, which oil slot should it be aligned to? Angle or one that will get plugged ?

Hello,thank you for replying, I am using the Burtz cam , what size hole do you recommend? Thanks again.

Hello pushed out cam bearing and drilled a 1/16 hole, seems a little small the rest are are around 1/4 ,also to align with oil passage it will be located around a 45 angle. Some pictures

Hello. I’m glad you have a sense of humor , my wife’s name is Honey Carol, she goes by Carol , took a lot of ribbing when she was younger.